hi guys i have a netgear nighthawk R7000 with the above firmware on, i am having an issue with DHCP not showing the reservations in DHCP screen so im not sure if they are working
my question is can i now update to a regular version now after i have upgraded to this version, my original firmware version was to high to go straight into a normal version hence the reason for the kognac custom build.
I don't have your router, so will let someone else confirm, but assume it's a matter of webupgrade (don't reset) or CLI flash method the current build (at time of writing).
Then after verifying a successful flash, displaying the new build number after boot, go ahead and reset to factory defaults to then configure from scratch (do not restore from backup).
If GUI factory defaults method for your router model isn't thorough enough there is "nvram erase && reboot" via Telnet command line, or a hardware reset (while it's fully booted up and running hold physical reset button for about 5-10 seconds according to your user manual).