Posted: Mon Sep 07, 2020 23:22 Post subject: Proper way to hard reset R7000?
I've been trying (and failing) to implement some changes to my R7000 configuration (more in another thread soon) and have managed to get it into a state several times where it will not respond to any device on the local network (wired or wireless, not even serving DHCP addresses), so I couldn't get in (web or ssh) to erase the nvram and try again.
By some dumb luck I managed to get in from the WAN side because I have DDNS and remote ssh setup. From there I managed to erase the nvram, get local access again and start over.
So I've done a lot of poking around the internet and this forum in particular and can't seem to find an answer that actually work.
30-30-30 is generally not recommended for the R7000 (ARM based router).
I found one post that suggested power-on, immediately press and hold reset for ~ 8 seconds.
Another suggested holding down the WPS button while applying power, then wait for the power LED to flash several times.
None of these worked, so either there is another way or I'm not doing something correctly.
So, if I'm going to continue locking myself out, I would like to have the ability to perform a factory reset/nvram erase without having to rely on the WAN back door, in case I manage to screw that up too.
Sorry, forgot the router and firmware info...
DD-WRT v3.0-r37985M kongac ( 12/16/18 ) _________________ WRT54GL modded to 32MB DRAM and 16MB Flash.