[smasher007]

Hi Egc,

Excellent work on the new updates, I cant wait for the killswitch option and policy-based routing to appear in the UI.

Btw, I was following your DDWRT Client Setup guide v05 for SolidVPN but haven't had any luck with it so far.

I am running the build DD-WRT v3.0-r43266 std on the R7000
I have an SB6141 sitting in front of an R7000 router. All my devices connect to the R7000 via wifi.

After I save the tunnel settings I lose connectivity and I am unable to access the internet. I tried restarting the router and waited for 10 mins. And, only after I disable tunnel that is when I get internet connectivity back.

See the below snippet for the wg status:

public key: GBKLALALALALALALALALLALAL=
private key: (hidden)
listening port: 51820

peer: blalalalalalalalaababababbaaba/j5zvLTE8=
preshared key: (hidden)
endpoint: 139.xx.xx.xx:51820
allowed ips: 0.0.0.0/0
transfer: 0 B received, 888 B sent
persistent keepalive: every 25 seconds

Any thoughts on what's wrong?
P.S: Wireguard server on ddwrt seems to be working just fine and my mobile devices can connect to it.

[egc]

I have split your post, hijacking is something which is frowned upon.

See the guide how you should setup for allowed IP's:
0.0.0.0/1,128.0.0.0/1

Enable Route Allowed IP's

Enable NAT out via Tunnel

Just look at the pictures and set accordingly

After setting up Save/Apply wait a couple of minutes

Reboot if it is not working

If it is still not working post a picture of the settings page

N.B. For running a WG server and WG Client at the same tima on the same router see the Advanced Setup guide (You have to use different ports and use PBR for the Client)