[thiswaythatway]

I am having an issue creating access restrictions for a laptop in my home network. When I enter the MAC address and or the IP. It seems to block the whole network.

This is on a Linksys AC3200 WRT3200ACM Open Source router flashed with r38060.

I have searched and cannot find anyone noting a similar problem. Or how to properly implement it. Although I feel the process is quite clear.

Name policy
Enable policy
Choose a client on the network by IP or MAC ( I choose either then both)
Saved it.
Applied settings.

Expected to see only that client being unable to access the WAN, only to find out no one could.


Please anyone if you see what I am doing wrong please advise. I would rather not have to flash again if not needed.

Thanks,