Ath0: AP, AC/N-Mixed
Mode: VHT80, 53
Bumped: TX and Gain but chip restricts to default
Short preamble
User Beamforming
Multiuser Beamforming
Beacon: 150
DTIM: 3
WMM
ACK 800
Bridged
Ath1: AP,
Mode: Dynamic(20/40 MHz), 6
Turbo
Bumped: TX and Gain but chip restricts to default
Short preamble
Beacon 100
DTIM 2
ACK 1500
Ath2: disabled
WPA2 Personal AES
bridged
Changed IP from default
Changed port from default
No problems on Factory to DDWRT flash
1.Having instability, disconnects and connect issues, lags/slowdowns – rebooting router fixes until next time.
2.I have read all that I have found. Basic setup for the 3200ACM. Advanced setup is not specific to 3200acm and Marvel chip. There are just a ton of other tabs that I can find no documentation.
Congestion control
Keep alive
Services…
Any links or other info other than install and basic setup you could point me to. Maybe another build?
Any references would be greatly appreciated.
At the time of this posting all was up and running for a good time. However every time I tried to get channel scan on the GUI (Site SurveY). It would hang up and the 5.0 connection would drop.
I just now had both AP's go down and having problem getting things working. No internet, can't connect.
Going to bed after a reboot and see in the AM.
I found that build next to impossible to use anytime I attempted to connect my android to the 5G, and the computer was less quirky, but could still cause issues... It seems to lock my router up and yet all leds but the wifi still seem to flash. I reverted back to 37305 and I am running smoothly again. Hope this gets some attention.
Posted: Sun Dec 22, 2019 22:12 Post subject: v3.0-r40188 std (07/04/19)
I am using v3.0-r40188 std (07/04/19) been very stable and trouble free. If you search for it i am sure it can be found however I am positive i downloaded it from dd-wrt router data base my self.