Posted: Sun Jan 31, 2021 20:22 Post subject: [closed] additional vlans setup
Hi,
I'm trying to create a setup with 2 additional vlans (id3 and id4), each of them leaving the router on port4 tagged, vlan3 with port2 untagged, vlan4 with port3 untagged.
I've confirmed that I can send vlan4 tagged on the cable that comes into port4 by connecting it directly to my laptop and setting up the same vlan on the network interface.
Any ideas or suggestions are much appreciated. Thanks!
Last edited by polaru on Tue Feb 02, 2021 8:01; edited 1 time in total
VLANS are hardware dependent, and as such, will having varying requirements. Questions regarding them are best asked in the forum for the router's specific chipset, which is the case of TP-Link is usually Atheros/Qualcomm.
Posted: Wed Feb 10, 2021 16:24 Post subject: Re: [closed] additional vlans setup
polaru wrote:
Hi,
I'm trying to create a setup with 2 additional vlans (id3 and id4), each of them leaving the router on port4 tagged, vlan3 with port2 untagged, vlan4 with port3 untagged.
I've confirmed that I can send vlan4 tagged on the cable that comes into port4 by connecting it directly to my laptop and setting up the same vlan on the network interface.
Any ideas or suggestions are much appreciated. Thanks!
I was able to setup VLANs on a C7 v2 with the swconfig command...
That actually helped! For some reason the web-ui showed the port was set to tagged, but `swconfig` showed it wasn't. I changed it, applied and it started working. Thanks a lot!
That actually helped! For some reason the web-ui showed the port was set to tagged, but `swconfig` showed it wasn't. I changed it, applied and it started working. Thanks a lot!
Awesome, I am glad it worked out for you. The GUI will not reflect changes to VLANs...