Posted: Wed May 08, 2019 6:39 Post subject: Netgear R7500v1 not boot after laste beta installation
Hi guys,
i need help with my netgear r7500v1. I try to install dd-wrt from oridinal fw but after upload and reboot my router start to bootloop. I try 30/30/30 reset and other tips but nobody works. Then i restored stock fw with tftp and try last openwrt and work. But I like ddwrt and I want this on my router. Can someone help me?
Stick with openwrt if it's working well. Install what you need with open to bring it up to dd-wrt. If there is something you want but don't have, revert openwrt back to stock firmware for your router and try again with dd-wrt.
Stick with openwrt if it's working well. Install what you need with open to bring it up to dd-wrt. If there is something you want but don't have, revert openwrt back to stock firmware for your router and try again with dd-wrt.
I Know that quantenna is not support but is not problem because my router use is only for VPN client and 2,4ghz is enough for me.
I try also any despiro version but not work.
did u tftp the KONG build .img.? (do not use brainslayer builds, buggy broken mess on ipq806x)
I've used only image from desipro site or from official page of dd-wrt site.
I tried to:
- Start from stock fw v1.0.0.94 and flash R7500v1-factory-to-ddwrt.img directly from web interface but after restart get bootloop.
- hard reset 30/30/30 but bootloop still remain
- Flash via tftp ddwrt.img bootloop still remain
- Flash via tftp openwrt work fine but have problem with wget 4 error
Seems a generic issue. Some one found the latest working version is build 33986. I can confirm, that one works on my r7500v1. While I want to use the 5 Ghz wifi I went back to the stock firmware, version V1.0.0.130.
I also have a r7800. That one runs the latest dd-wrt build without issues. However I can not get Entware opkg working on the lastest build.
I am thinking of selling the r7500v1 and buying a more dd-wrt friendly router.
