NTP with Netgear R7000 in AP mode

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Hardware DIY / Hardware Mods
Author Message
implodespw
DD-WRT Novice


Joined: 22 Aug 2019
Posts: 1

PostPosted: Thu Aug 22, 2019 14:54    Post subject: NTP with Netgear R7000 in AP mode Reply with quote
Had a fair bit of issues getting my R7000 to sync with my NTP server running Chrony. I have read a few older posts where this has been an issue for some.

I have my R7000 connected to a Cisco 1921 and a server running a CentOS VM with Chrony on it. All of my devices but the AP could sync with the NTP server. That was even after I upgraded the DD-WRT to the latest update.

What finally fixed it was setting the NTP server on the R7000 to the loopback address on the Cisco Router. Now my Netgear R7000 is pulling time.

Hope this helps someone.
Sponsor
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Hardware DIY / Hardware Mods All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum