I saw that on the isp website. It was not clear as to which one to use.
I setup the dmz on (isp modem/router) and had "use external ip" checked but I still could not connect to my router from outside the local lan. _________________ WRT1900ACSV2-Router
Firmware: DD-WRT v3.0-r39855 std (05/25/19)
Hi
Okay...
I have the DMZ working. The problem was I had the same ports open on my isp modem/router.
Still no ideal why I cannot get a connection in bridge mode. I will keep looking for a solution to get this working.
Thanks
Mike _________________ WRT1900ACSV2-Router
Firmware: DD-WRT v3.0-r39855 std (05/25/19)
The problem with the modem working in transparent bridging is now fixed. I am not sure why it started working.
There was an outage in the area, so when my service was restored I decided to try again and this time it worked. I am guessing there was a programming issue on their side.
Thanks to everyone that helped me with a workaround.
Hi
I actually used dchp which is basically the same as ipoe.
I had settings on the modem that were incorrect for the ipoe. _________________ WRT1900ACSV2-Router
Firmware: DD-WRT v3.0-r39855 std (05/25/19)