[WildBillpdx]

I bricked my WRT32X trying to restore stock firmware. Now can't get to a point in the boot process to even restore via serial connection. All I get during boot is this:

BootROM - 1.73

Booting from NAND flash


General initialization - Version: 1.0.0

AVS selection from EFUSE disabled (Skip reading EFUSE values)

mvSysEnvIsFlavourReduced: TWSI Read of 'flavor' failed

Detected Device ID 6820

High speed PHY - Version: 2.0


Init RD NAS topology Serdes Lane 3 is USB3

Serdes Lane 4 is SGMII

board SerDes lanes topology details:

| Lane # | Speed| Type |

------------------------------|

| 0 | 6 | SATA0 |

| 1 | 5 | PCIe0 |

| 2 | 6 | SATA1 |

| 3 | 5 | USB3 HOST1 |

| 4 | 5 | PCIe1 |

| 5 | 0 | SGMII2 |

-------------------------------

:** Link is Gen1, check the EP capability

PCIe, Idx 0: Link upgraded to Gen2 based on client cpabilities

:** Link is Gen1, check the EP capability

PCIe, Idx 1: remains Gen1

High speed PHY - Ended Successfully

DDR3 Training Sequence - Ver TIP-1.46.0

mvSysEnvGetTopologyUpdateInfo: TWSI Read failed

DDR3 Training Sequence - Switching XBAR Window to FastPath Window

DDR3 Training Sequence - Ended Successfully

Not detected suspend to RAM indication

BootROM: Image checksum verification PASSED




U-Boot 2013.01 (May 18 2017 - 16:37:44) Marvell version: 2015_T1.QA.0p16

Boot version : v2.0.9

Board: RD-NAS-88F6820-DDR3
SoC: MV88F6820 Rev A0
running 2 CPUs
CPU: ARM Cortex A9 MPCore (Rev 1) LE
CPU 0
CPU @ 1866 [MHz]
L2 @ 933 [MHz]
TClock @ 200 [MHz]
DDR3 @ 933 [MHz]
DDR3 32 Bit Width,FastPath Memory Access, DLB Enabled, ECC Disabled
DRAM: 512 MiB
NAND: 256 MiB
MMC: mv_sdh: 0

Then everything just stops. Can't enter any commands. Any help would be greatly appreciated.