Netgear errors in log

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware
Author Message
thommy181
DD-WRT Novice


Joined: 16 Mar 2019
Posts: 25
Location: Szczecin, Poland EU

PostPosted: Thu Jun 20, 2019 9:57    Post subject: Netgear errors in log Reply with quote
My earlier problem with ttl is solved. After restart my device I have an errors in log:
Quote:
Jan 1 01:00:08 Myrouter syslog.info syslogd started: BusyBox v1.30.1
Jan 1 01:00:08 Myrouter user.info : klogd : daemon successfully started
Jan 1 01:00:08 Myrouter kern.info kernel: UDP hash table entries: 256 (order: 0, 4096 bytes)
Jan 1 01:00:08 Myrouter kern.info kernel: UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
Jan 1 01:00:08 Myrouter kern.info kernel: NET: Registered protocol family 1
Jan 1 01:00:08 Myrouter kern.debug kernel: PCI: CLS 0 bytes, default 32
Jan 1 01:00:08 Myrouter kern.info kernel: squashfs: version 4.0 (2009/01/31) Phillip Lougher
Jan 1 01:00:08 Myrouter kern.info kernel: msgmni has been set to 244
Jan 1 01:00:08 Myrouter kern.info kernel: io scheduler noop registered (default)
Jan 1 01:00:08 Myrouter kern.info kernel: HDLC line discipline maxframe=4096
Jan 1 01:00:08 Myrouter kern.info kernel: N_HDLC line discipline registered.
Jan 1 01:00:08 Myrouter kern.info kernel: Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
Jan 1 01:00:08 Myrouter kern.info kernel: serial8250: ttyS0 at MMIO 0x0 (irq = Cool is a U6_16550A
Jan 1 01:00:08 Myrouter kern.info kernel: brd: module loaded
Jan 1 01:00:08 Myrouter kern.err kernel: pflash: found no supported devices
Jan 1 01:00:08 Myrouter kern.warn kernel: ERROR: Unknown flash, device_id:0x00
Jan 1 01:00:08 Myrouter kern.err kernel: bcmsflash: found no supported devices
Jan 1 01:00:08 Myrouter kern.debug kernel: Bad block table found at page 65472, version 0x01
Jan 1 01:00:08 Myrouter kern.debug kernel: Bad block table found at page 65408, version 0x01
Jan 1 01:00:08 Myrouter kern.notice kernel: Creating 2 MTD partitions on "brcmnand":
Jan 1 01:00:08 Myrouter kern.notice kernel: 0x000000500000-0x000002000000 : "linux"
Jan 1 01:00:08 Myrouter kern.notice kernel: 0x000004000000-0x000007f00000 : "ddwrt"
Jan 1 01:00:08 Myrouter kern.warn kernel: Boot partition size = 524288(0x80000)
Jan 1 01:00:08 Myrouter kern.warn kernel: lookup_nflash_rootfs_offset: offset = 0x500000


I have dd-wrt build 16 Jun 19 and Netgear 3500Lv2 router. It's hard to say the problem is earlier or appear today. My devices connected to router. 1x ISP Modem to WAN port, 2 ports of Lan: 1x gigabit port for internet connection to my PC via rj-45, 1x 100 mbit lan port for voip gateway is connected via rj-45 too. Other devices connected via wi-fi: laptop, 2x Android smartphones. That's all and #3 and #4 LAN ports are completly disabled. I don't know what's that errors. Can you help me again ?
Sponsor
jwh7
DD-WRT Guru


Joined: 25 Oct 2013
Posts: 2309
Location: Indy

PostPosted: Thu Jun 20, 2019 13:43    Post subject: Re: Netgear errors in log Reply with quote
thommy181 wrote:
    Jan 1 01:00:08 Myrouter kern.info kernel: Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
    Jan 1 01:00:08 Myrouter kern.info kernel: serial8250: ttyS0 at MMIO 0x0 (irq = Cool is a U6_16550A
    Jan 1 01:00:08 Myrouter kern.info kernel: brd: module loaded
    Jan 1 01:00:08 Myrouter kern.err kernel: pflash: found no supported devices
    Jan 1 01:00:08 Myrouter kern.warn kernel: ERROR: Unknown flash, device_id:0x00
    Jan 1 01:00:08 Myrouter kern.err kernel: bcmsflash: found no supported devices
    Jan 1 01:00:08 Myrouter kern.debug kernel: Bad block table found at page 65472, version 0x01
    Jan 1 01:00:08 Myrouter kern.debug kernel: Bad block table found at page 65408, version 0x01
    Jan 1 01:00:08 Myrouter kern.notice kernel: Creating 2 MTD partitions on "brcmnand":
So you're not having any issues, just curious about the log messages? The 3500Lv2 has NAND flash, which commonly has bad blocks, and the firmware is giving errors because there is no NOR flash (and/or other devices that other router might have), which is correct. So don't worry about it. Wink

thommy181 wrote:
My earlier problem with ttl is solved.
You should post what the problem was, and preferably also mark the post subject (via editing the first post) as [solved].
_________________
# NAT/SFE/CTF: limited speed w/ DD # Repeater issues # DD-WRT info: Builds, Types, Modes, Changelog, Peacock, Demo #
x64 OPNsense 19.7.2|EA6900v1.1@1GHz FT 2019.3b|DD 40599: WNDR4500v2, WNDR4000@533, E1500@353, R6300v1,
2*E2500, WRT54*@250: GLv1.1 nsg, GSv6 µ
|RT-N66U@663 Merlin 380.70|OEM: WGR614v10@400-WNR1000v3 mod
thommy181
DD-WRT Novice


Joined: 16 Mar 2019
Posts: 25
Location: Szczecin, Poland EU

PostPosted: Sat Jul 20, 2019 12:08    Post subject: Reply with quote
Actually i have dd-wrt build DD-WRT v3.0-r40352 giga and warnings and errors are still. That's similar as earlier.
Quote:
Jan 1 01:04:28 Myrouter kern.warn kernel: Found a AMD NAND flash with 2048B pages or 128KB blocks; total size 128MB
Jan 1 01:04:28 Myrouter kern.warn kernel: Zone ranges:
Jan 1 01:04:28 Myrouter kern.warn kernel: Normal [mem 0x00000000-0x07ffefff]
Jan 1 01:04:28 Myrouter kern.warn kernel: HighMem empty
Jan 1 01:04:28 Myrouter kern.warn kernel: Movable zone start for each node
Jan 1 01:04:28 Myrouter kern.warn kernel: Early memory node ranges
Jan 1 01:04:28 Myrouter kern.warn kernel: node 0: [mem 0x00000000-0x07ffefff]
Jan 1 01:04:28 Myrouter kern.warn kernel: Primary instruction cache 32kB, 4-way, VIPT, I-cache aliases, linesize 32 bytes.
Jan 1 01:04:28 Myrouter kern.warn kernel: Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Jan 1 01:04:28 Myrouter kern.warn kernel: Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32511
Jan 1 01:04:28 Myrouter kern.warn kernel: PCI: Fixing up bus 0
Jan 1 01:04:28 Myrouter kern.err kernel: pflash: found no supported devices
Jan 1 01:04:28 Myrouter kern.warn kernel: ERROR: Unknown flash, device_id:0x00
Jan 1 01:04:28 Myrouter kern.err kernel: bcmsflash: found no supported devices
Jan 1 01:04:28 Myrouter kern.warn kernel: Boot partition size = 524288(0x80000)
Jan 1 01:04:28 Myrouter kern.warn kernel: lookup_nflash_rootfs_offset: offset = 0x500000
Jan 1 01:04:28 Myrouter kern.warn kernel: Failed to load ipt action
Jan 1 01:04:28 Myrouter kern.warn kernel: nf_conntrack_rtsp v0.7 loading
Jan 1 01:04:28 Myrouter kern.warn kernel: nf_nat_rtsp v0.7 loading
Jan 1 01:04:28 Myrouter kern.warn kernel: et: module license 'Proprietary' taints kernel.
Jan 1 01:04:28 Myrouter kern.warn kernel: Disabling lock debugging due to kernel taint
Jan 1 01:04:28 Myrouter kern.warn kernel: et_module_init: passivemode set to 0x0
Jan 1 01:04:28 Myrouter kern.warn kernel: et_module_init: txworkq set to 0x0
Jan 1 01:04:28 Myrouter kern.warn kernel: et_module_init: et_txq_thresh set to 0xce4
Jan 1 01:04:28 Myrouter kern.warn kernel: et_module_init: et_rxlazy_timeout set to 0x3e8
Jan 1 01:04:28 Myrouter kern.warn kernel: et_module_init: et_rxlazy_framecnt set to 0x20
Jan 1 01:04:28 Myrouter kern.warn kernel: et_module_init: et_rxlazy_dyn_thresh set to 0
Jan 1 01:04:28 Myrouter kern.warn kernel: eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 7.14.89.21 (r524987)

Router working not without small problems. I'm describe them in other post
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Broadcom SoC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum