Posted: Sat Jun 15, 2019 10:41 Post subject: can not change partitions
I have wrt1900acs v2 i have stock firmware on one part & dd-wrt on the other part ican not switch beteen partions i am stuck in stock i have tried power 4 times telnet ssh ihave tried previous firmware when it finishes the power light flashes i have no internet the only way i can get back to stock is to do 30/30/30 stock works fine thank u barry
You gotta read the "Cliff Notes" sticky thread at the top of this forum, before doing anything. It first tells you not to do 30/30/30 on these routers, plus other useful life-saving stuff.
Since you are stuck on stock now, try to flash factory-to-ddwrt. This will flash dd-wrt to the other partition. The Cliff Notes thread will tell you how to make use of the boot_part setting to preserve the stock/ddwrt partitions. _________________
Netgear R7800 kongpro 19.07 20190711 || Netgear R7000 35550M kongac (Client Bridge=5GHz, AP=2.4GHz)
Linksys WRT32X davidc502 OpenWrt || Linksys WRT1200ACv1 Gargoyle 1.11.x
Linksys WRT1900ACSv2 dd-wrt 39956