Posted: Sat Dec 29, 2018 10:59 Post subject: Tag WAN port with VID / VLAN 300
I've got a fiber internet connection (from T-mobile Thuis, Netherlands) and would like to use my own router rather than the modem provided by my ISP.
Looking at the ISP's modem configuration & reading online I'm confident my ISP has 3 VLANS
- Internet: vid 300
- TV: vid 640
- Management: vid 100
I am only interested in the internet part. On my Netgear R7000 (stock firmware), I could add this VLAN using the IPTV option (https://kb.netgear.com/29911/Configuring-VLAN-IPTV-setup-on-your-Nighthawk-router)
However, I am struggling to get this working using dd-wrt.
I read many conflicting posts on this forum. Some say Broadcom chipset only supports 15 VLANs, some say later dd-wrt builds support up to 4096 VLANs and others claim VLANs and tag/vids are different things.
Is it possible to have my router get an internet connection using dd-wrt when my ISP uses VLAN 300?
NETGEAR R7000 AC1900
Using the latest Kong build (http://www.desipro.de/ddwrt/K3-AC-Arm/) First updated to dd-wrt.K3_R7000.chk then dd-wrt.v24-K3_AC_ARM_STD.bin 2018-09-23)
Posted: Fri Jul 19, 2019 5:30 Post subject: vlan tagging
I am trying to do the same thing as Xeli. Setting up a tplink archer C7.v2 for t-mobile thuis. I understand most of what he is doing but I am confused about the tagging of the vlans. When I go to the "Setup-networking" page I can apperently only tag interfaces. Looking at ifconfig I see that eth0 is my wan interface. So I think that should be the one to be tagged. But what is my cpu interface? the bridge?
My dd-wrt interface is