Is it possible to support IPv6 NAT table?

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Advanced Networking
Author Message
sxlllslgh
DD-WRT Novice


Joined: 14 Jul 2019
Posts: 1

PostPosted: Sun Jul 14, 2019 10:15    Post subject: Is it possible to support IPv6 NAT table? Reply with quote
It seems IPv6 NAT table is not supported now. My ISP only give me a single IPv6 address by DHCPv6, and I tried all methods I could find but no one worked.
In fact, I can get an IPv6 address with 64 bits prefix in my router like 20XX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX/64 with DHCPv6 Prefix Delegation enabled. And if I enable radvd and set prefix to be the same as the router got (even I think it should not be set manually), my devices on LAN could also get IPv6 addresses and resovle domains, but could not ping or connect router or the Internet.
I once tried IPv6 nat on an OpenWRT router and it worked. But the nat table does not exist in the ip6tables of dd-wrt now, so is it possible to update the ip6tables version of dd-wrt?
Sponsor
Per Yngve Berg
DD-WRT Guru


Joined: 13 Aug 2013
Posts: 5131
Location: Akershus, Norway

PostPosted: Sun Jul 14, 2019 11:44    Post subject: Reply with quote
This sound like a routing issue.

I use dnsmasq rather than radvd.

Disable radvd and put this in additional dnsmasq option:

quiet-dhcp
quiet-dhcp6
quiet-ra
enable-ra
dhcp-range=::10,::200,constructor:br0,ra-names,slaac,64,24h

Can you ping6 anything on Internet from the router?
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Advanced Networking All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum