Author
Message
GeneralSP DD-WRT Novice Joined: 14 May 2019 Posts: 4
Posted: Tue May 14, 2019 13:18 Post subject: Use IPTV device with x86 64 based and multicast questions?
Hi folks, I use X64 based DD-WRT with VirtualBox. All working good accept my new IPTV boxe.
When I disable Multicast filter, the IPTV work great but I have a lot of packets spreaded in my network.
Can I isolate it with mac, IP or other things my IPTV boxe in my network?
or stop the multicasting packet flooding, use it only for my IPTV boxe?
Thanks!
Back to top
Sponsor
GeneralSP DD-WRT Novice Joined: 14 May 2019 Posts: 4
Posted: Mon May 20, 2019 14:57 Post subject:
Near 80 read and no help!
Back to top
GeneralSP DD-WRT Novice Joined: 14 May 2019 Posts: 4
Posted: Fri May 31, 2019 12:22 Post subject:
WAW! I'm very impressed about help here!
Back to top
flood404 DD-WRT User Joined: 18 Dec 2013 Posts: 336
Posted: Sun Jun 02, 2019 18:58 Post subject:
Only a few people use the x86 or the x64 bit versions of dd-wrt the rest of them use it on a routers made by various manufactures.
I would use dd-wrt on real hardware and not with a virtual box setup.
I have an Android TV box and it loves trying to connect to a server located in China with over 2000 connections which takes awhile for it to give up.
Back to top
Per Yngve Berg DD-WRT Guru Joined: 13 Aug 2013 Posts: 6870 Location: Romerike, Norway
Posted: Sun Jun 02, 2019 19:10 Post subject:
How many interfaces are there on the dd-wrt router?
Do you have a switch in your network?
With a smart switch, you can enable IGMP-snooping on specific ports.
The IGMPproxy on the dd-wrt router can also be configured by the igmpproxy.conf file.
Back to top
GeneralSP DD-WRT Novice Joined: 14 May 2019 Posts: 4
Posted: Sun Jun 02, 2019 23:01 Post subject:
Thanks guys,
I using a PC with virtualbox because I can use the same PC for others things, like a FTP Windows server. This PC don't have Internet access, only Local. I have a 16 ports switch connected on the Lan port. This switch is not smart, can't use IGMP. Can you explain to me how make a Vlan (tag) or use the igmpproxy.conf ?
Back to top
Per Yngve Berg DD-WRT Guru Joined: 13 Aug 2013 Posts: 6870 Location: Romerike, Norway
Posted: Sat Jun 15, 2019 17:23 Post subject:
Here is an example of igmpproxy.conf
Code: quickleave
phyint eth0 upstream ratelimit 0 threshold 1
phyint br0 downstream ratelimit 0 threshold 1
phyint eth1 disabled
phyint eth1.3 downstream ratelimit 0 threshold 1
phyint ath0 disabled
phyint ath0.1 disabled
phyint ath1 disabled
phyint br1 disabled
phyint oet1 disabled
phyint lo disabled
You have one upstream interface or either downstream or disabled interfaces.
If your switch is not smart, it will treat multicast as broadcast and forward to every port.
Back to top