Joined: 03 Jul 2018
|Posted: Fri Jun 14, 2019 3:57 Post subject: Linksys WRT32X & D-Link DIR601 WDS/Wireless Bridge
I have been trying to get my two DD-WRT routers to work together as a wireless bridge. I have followed a guide on YouTube, but it's not working.
I have both APs in AP mode, same network settings (channel, password, authentication, mode, etc.). On the client router I have the host's wireless MAC added to WDS, set to router in advanced routing, SPI firewall turned off, and have set an IP and gateway address ( for host's IP) into the setup page.
On the host router, I have the wireless MAC of the client router in WDS.
I have restarted both several times, but nothing seems to work.
I have tried to do this many times, and have hard reset my client router about 15 times already today. I would like some help on this.
Please, send me a guide, video, etc. to get this working.
I even tried putting in all three MAC addresses of the Host router into the client routers WDS (it's a 3 AP plus LAN router and using the 3rd AP for this test), and I put both wireless and LAN MAC addresses in the hosts WDS under LAN; still cannot get it to work.
I'm running 39572 on the Host and 40009 on the client (versions of DD-WRT).