Trouble set up Guest Networking wl0.1 & wl1.1 with bridg

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Advanced Networking
Goto page Previous  1, 2
Author Message
puterboy2
DD-WRT Novice


Joined: 24 Feb 2019
Posts: 24

PostPosted: Tue Jun 11, 2019 4:43    Post subject: 'Save Firewall' gives repeated entries Reply with quote
I added the below command to the "Save Firewall..." statement under Administration->Commands
Quote:

ebtables -I FORWARD --logical-in br1 --logical-out br1 -j DROP


However, when I ssh into the router and run: ebables -L
I get that the command is repeated multiple times (2 or 3 depending on what other firewall commands I have).

Quote:

Bridge table: filter

Bridge chain: INPUT, entries: 0, policy: ACCEPT

Bridge chain: FORWARD, entries: 3, policy: ACCEPT
--logical-in br1 --logical-out br1 -j DROP
--logical-in br1 --logical-out br1 -j DROP
--logical-in br1 --logical-out br1 -j DROP

Bridge chain: OUTPUT, entries: 0, policy: ACCEPT


Any idea why the command would be run multiple times?
Sponsor
NoAhBoDy
DD-WRT Novice


Joined: 20 Mar 2008
Posts: 12

PostPosted: Tue Jul 09, 2019 6:03    Post subject: Reply with quote
egc wrote:
On a first glance your setup seems OK.

I would use the same encryption (WPA2/AES) in the past there were problems connecting if the encryption was different.

The latest build is not a very accurate description of the build number, in the latest Kong test build as of now 39855 VAP's are supposed to work better (but I have not verified that), in earlier builds VAP's were problemtatic and needed work arounds to start, from one of the build threads:

From approximately mid 2018 VAP's on Broadcom units are problematic, you cannot connect or do not get an IP address. There are workarounds :
1) When VAP is not working at boot; workaround startup command Administrationn/Commands, Save as Startup:
sleep 10; stopservice nas; stopservice wlconf; startservice wlconf; startservice nas;
2) Alternative way to get VAP working: https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=317181
3) An other user reports the following workaround (save as startup):
sleep 4; stopservice cron; stopservice wlconf; wlconf eth1 up; wlconf eth2 up; startservice cron;
https://forum.dd-wrt.com/phpBB2/viewtopic.php?t=319412
4)This one is from @Redhawk (guaranteed to work Wink ):
sleep 20; stopservice nas; wlconf eth1 down; wlconf eth2 down; wlconf eth1 up; wlconf eth2 up; startservice nas


Thanks! I just setup an Asus RT-AC68U with fw 37305 and for the life of me could not get an IP on my guest wireless. Option 4 (@Redhawk) fixed it up for me. I spent a couple hours trying to figure this out as I had it working perfectly on my old Linksys E3000.

_________________
Hey...where'd my sig go?(*#)@#%
Goto page Previous  1, 2 Display posts from previous:    Page 2 of 2
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Advanced Networking All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum