Easybox 803A

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> ARM oder PPC basierte Hardware
Author Message
Cyberscitymaste
DD-WRT Novice


Joined: 03 Aug 2015
Posts: 1

PostPosted: Mon Aug 03, 2015 20:01    Post subject: Easybox 803A Reply with quote
hallo Ich brauchte echt mal hilfe
bekomme openwrt einfach nicht ans Laufen

hab mir schon 2 stück geplättet die ich aber mit dem Uart mode soweit wieder ins leben rufen konnte
doch bei beiden bleibt der Boot vorgang hängen

U-Boot 2013.10-openwrt4 (May 28 2014 - 21:46:54) ARV752DPW22

Board: Arcadyan ARV752DPW22
SoC: Lantiq Danube-S v1.5
CPU: 333.333 MHz
IO: 166.667 MHz
BUS: 83.333 MHz
BOOT: NOR
DRAM: 64 MiB
Flash: 8 MiB
In: serial
Out: serial
Err: serial
Net: ltq-eth
Hit any key to stop autoboot: 0
## Booting kernel from Legacy Image at b0040000 ...
Image Name: MIPS OpenWrt Linux-3.10.49
Created: 2014-10-02 7:14:02 UTC
Image Type: MIPS Linux Kernel Image (lzma compressed)
Data Size: 1446409 Bytes = 1.4 MiB
Load Address: 80002000
Entry Point: 80002000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel ...

[ 0.000000] Linux version 3.10.49 (bb@builder1) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r42625) ) #5 Wed Oct 1 15:41:21 CEST 2014
[ 0.000000] SoC: Danube rev 1.5
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU revision is: 00019641 (MIPS 24KEc)
[ 0.000000] MIPS: machine is ARV7510PW22 - Astoria Networks
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 04000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x00000000-0x03ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x00000000-0x03ffffff]
[ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
[ 0.000000] Kernel command line: console=ttyLTQ0,115200 init=/etc/preinit
[ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Writing ErrCtl register=00000008
[ 0.000000] Readback ErrCtl register=00000008
[ 0.000000] Memory: 60496k/65536k available (3163k kernel code, 5040k reserved, 867k data, 184k init, 0k highmem)
[ 0.000000] NR_IRQS:256
[ 0.000000] CPU Clock: 333MHz
[ 0.000000] Calibrating delay loop... 221.18 BogoMIPS (lpj=442368)
[ 0.036000] pid_max: default: 32768 minimum: 301
[ 0.040000] Mount-cache hash table entries: 512
[ 0.048000] pinctrl core: initialized pinctrl subsystem
[ 0.052000] NET: Registered protocol family 16
[ 0.072000] pinctrl-xway 1e100b10.pinmux: Init done
[ 0.076000] dma-xway 1e104100.dma: Init done - hw rev: 3, ports: 5, channels: 20
[ 0.088000] PCI host bridge /fpi@10000000/pci@E105400 ranges:
[ 0.092000] MEM 0x0000000018000000..0x0000000019ffffff
[ 0.096000] IO 0x000000001ae00000..0x000000001affffff
[ 0.120000] bio: create slab <bio-0> at 0
[ 0.128000] usbcore: registered new interface driver usbfs
[ 0.132000] usbcore: registered new interface driver hub
[ 0.136000] usbcore: registered new device driver usb
[ 0.140000] PCI host bridge to bus 0000:00
[ 0.144000] pci_bus 0000:00: root bus resource [mem 0x18000000-0x19ffffff]
[ 0.148000] pci_bus 0000:00: root bus resource [io 0x1ae00000-0x1affffff]
[ 0.152000] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
[ 0.160000] pci 0000:00:0e.0: BAR 0: assigned [mem 0x18000000-0x1800ffff]
[ 0.164000] pci 0000:00:0f.2: BAR 0: assigned [mem 0x18010000-0x180100ff]
[ 0.168000] pci 0000:00:0f.0: BAR 4: assigned [io 0x1ae00000-0x1ae0001f]
[ 0.172000] pci 0000:00:0f.1: BAR 4: assigned [io 0x1ae00020-0x1ae0003f]
[ 0.176000] pci 0000:00:0e.0: SLOT:14 PIN:1 IRQ:30
[ 0.180000] pci 0000:00:0f.0: SLOT:15 PIN:1 IRQ:135
[ 0.184000] pci 0000:00:0f.1: SLOT:15 PIN:2 IRQ:135
[ 0.188000] pci 0000:00:0f.2: SLOT:15 PIN:3 IRQ:135
[ 0.192000] Switching to clocksource MIPS
[ 0.200000] NET: Registered protocol family 2
[ 0.208000] TCP established hash table entries: 512 (order: 0, 4096 bytes)
[ 0.216000] TCP bind hash table entries: 512 (order: -1, 2048 bytes)
[ 0.220000] TCP: Hash tables configured (established 512 bind 512)
[ 0.228000] TCP: reno registered
[ 0.232000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.236000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.244000] NET: Registered protocol family 1
[ 0.248000] PCI: Enabling device 0000:00:0f.0 (0000 -> 0001)
[ 0.252000] PCI: Enabling device 0000:00:0f.1 (0000 -> 0001)
[ 0.260000] PCI: Enabling device 0000:00:0f.2 (0000 -> 0002)
[ 0.264000] gptu: totally 6 16-bit timers/counters
[ 0.272000] gptu: misc_register on minor 63
[ 0.276000] gptu: succeeded to request irq 126
[ 0.280000] gptu: succeeded to request irq 127
[ 0.284000] gptu: succeeded to request irq 128
[ 0.288000] gptu: succeeded to request irq 129
[ 0.292000] gptu: succeeded to request irq 130
[ 0.296000] gptu: succeeded to request irq 131
[ 0.308000] lantiq,vmmc 1f103000.vmmc: requested GPIO 233
[ 0.312000] lantiq,vmmc 1f103000.vmmc: reserved 1MB at 0x03900000
[ 0.324000] ralink,eeprom ralink_eep.4: using RT2860.eeprom as eeprom
[ 0.332000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.340000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.348000] msgmni has been set to 118
[ 0.356000] io scheduler noop registered
[ 0.360000] io scheduler deadline registered (default)
[ 0.368000] 1e100c00.serial: ttyLTQ0 at MMIO 0x1e100c00 (irq = 112) is a lantiq,asc
[ 0.372000] console [ttyLTQ0] enabled, bootconsole disabled
[ 0.372000] console [ttyLTQ0] enabled, bootconsole disabled
[ 0.388000] ltq_nor: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x00007f Chip ID 0x0022cb
[ 0.396000] Amd/Fujitsu Extended Query Table at 0x0040
[ 0.404000] Amd/Fujitsu Extended Query version 1.1.
[ 0.408000] number of CFI chips: 1
[ 0.412000] 4 ofpart partitions found on MTD device ltq_nor
[ 0.416000] Creating 4 MTD partitions on "ltq_nor":
[ 0.420000] 0x000000000000-0x000000040000 : "uboot"
[ 0.428000] 0x000000040000-0x000000060000 : "uboot_env"
[ 0.436000] 0x000000060000-0x000000fe0000 : "firmware"
[ 0.440000] mtd: partition "firmware" extends beyond the end of device "ltq_nor" -- size truncated to 0x7a0000
[ 0.520000] 0x000000fe0000-0x000001000000 : "board_config"
[ 0.524000] mtd: partition "board_config" is out of reach -- disabled