Joined: 09 Nov 2014 Posts: 314 Location: Bakersfield, CA
Posted: Sat Jan 12, 2019 20:15 Post subject:
Router/Version: Trendnet TEW811DRU
Firmware: DD-WRT v3.0-r38253 mini (01/10/19)
Kernel: Linux 4.4.169 #4454 Thu Jan 10 09:31:27 CET 2019 armv7l
Mode: Overclocked AC only client bridge, with all settings NOT required for a basic working bridge turned off.
Status: Seems good, speed tests are stable. Gonna test the "enter command" issue mentioned above and see if I can get it. If so I'll just reboot it and we'll know. Gimmie a few. Thanks for the hard work, devs!
NOTE: Running commands via the GUI interface seems to be working fine on my E3000 units. _________________ Deployed Routers:
Netgear R7800 - 1x build 46979
- Gateway (USB /w Entware, CAKE QoS)
Netgear R7000 - 3x build 46979
Router/Version: Asus RT-N66U
File: dd-wrt.v24-38253_NEWD-2_K3.x-big-RT-N66U
Firmware: DD-WRT v3.0-r38253M big (01/10/19)
Kernel: Linux 3.10.108-d7 #22551 Thu Jan 10 16:25:45 CET 2019 mips
Mode: Gateway / privoxy, Wifi disabled
Reset: No
Status: working as intended, uptime 1h
Router/Version: Asus RT-N12D1
File: dd-wrt.v24-38253_NEWD-2_K3.x_mega_RT-N12B1 (D1 revision uses same HW as B1)
Firmware: DD-WRT v3.0-r38253M mega (01/10/19)
Kernel: Linux 3.10.108-d7 #22555 Thu Jan 10 16:32:53 CET 2019 mips
Mode: Gateway, connected via WAN to N66U
Reset: No
Status: working as intended, uptime 1h
Joined: 09 Nov 2014 Posts: 314 Location: Bakersfield, CA
Posted: Thu Jan 17, 2019 23:42 Post subject:
Just a note here: On my Trendnet TEW811DRU AC-only client bridge, it would frequently drop connection. Never had a problem with the latest build, but this one seems. Speedtests are a bit slower too. _________________ Deployed Routers:
Netgear R7800 - 1x build 46979
- Gateway (USB /w Entware, CAKE QoS)
Netgear R7000 - 3x build 46979
I flashed this build on E1200 v2, but seems DDNS is not working.
Code:
Fri Jan 18 22:49:20 2019: INADYN: Started 'INADYN Advanced version 1.96-ADV' - dynamic DNS updater.
Fri Jan 18 22:49:20 2019: I:INADYN: IP address for alias 'all.dnsomatic.com' needs update to 'my new ip here'
Fri Jan 18 22:49:20 2019: I:INADYN: Alias 'all.dnsomatic.com' to IP 'my new ip here' updated successfully.
But when I open DNSOMatic, my IP address is the old one and is not updating to the new once since I flashed the firmware.
