Posted: Tue Apr 24, 2018 18:32 Post subject: R7000 reset settings after shutdown router.
Hi, R7000 reset settings when the router is turned off. My firmware is Kong ( 3/28/18 ). When the router starts, the settings are default. Can I fix the problem somehow? I'd rather not change the firmware because it suits me best.
When I upload the default Genie firmware. The R7000 keeps settings.
You don't want to do research
You don't want to take advice
What exactly are you looking for here on this forum?
DD-WRT did not cause your problem
Though if you had read & followed the Peacock Thread part 9. Before playing with Vortex, you'd be in a much better spot right now _________________ Location 1
R6300V2- DD-WRT v3.0-r39345M kongac (04-03-19) Gateway
WNDR3400v1 DD-WRT.v3.0-r35531_mega-nv64k (03/26/18 ) Access Point
WRT160Nv3 DD-WRT ?v3?.0-r35531 mini (03/26/18 ) Access Point
WRT54GSv5 DD-WRT v24-r33555_micro_generic (10/20/17) Repeater
R6300V2- DD-WRT v3.0-r39345M kongac (04/03/19) Gateway
R6300V2- DD-WRT v3.0-r39345M kongac (04/03/19) Access Point
WNDR3700v2 DD-WRT v3.0-r35531 std (03/26/18 ) Access Point
E1200 v2 DD-WRT v3.0-r35531 mega-nv64k (03/26/18 ) Gateway(for trivial reasons)
2 devices: SXT 5 ac (mipsbe) RB 6.46.4 (2/21/20) PTP Bridge (0.8km/0.5mi)tx/rx866.6Mbps-1GbpsLAN
Thank You BrainSlayer & <Kong> for ALL that you do & have done, also to "most" everyone here that shares their knowledge