Posted: Sun Oct 14, 2018 4:17 Post subject: Modified firmware for DLink DIR 615 E1?
Hi there, I am struggling to figure out how to modify the hex values for this version of router even though I downloaded the original firmware off the site and read that the hex values should be at the end of the firmware file name but I do not see it. Does anybody have a modified and working version of this firmware?
Did you try the Factory-to-ddwrt file from the link in my signature first? What about flashing it from the D-Link Recovery room? _________________ Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
QCA Best WiFi Settings
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one.
Atheros:
Netgear R7800 x3 - WDS AP / station, gateway, QoS
TP-Link Archer C7 v2 x2 - WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - NU
D-Link 615 C1/E3/I1 x 7 - 1 WDS station
D-Link 825 B1 - NU
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - NU
UBNT loco M2 x2 - airOS
Broadcom
Linksys EA6400 - Gateway, QoS
Asus N66U - AP
Netgear WNDR3700v3 - not used
MediaTek
UBNT EdgeRouter X - switch
Posted: Tue Oct 16, 2018 22:23 Post subject: Modified firmware for DLink DIR 615 E1?
I have tried several firmwares up to this point and cannot get past the page in the attached screenshot. I have also tried the emergency reboot method (pull power while holding reset and waiting for the orange light to flash) and it still does not seem to get past the screen in the attached even when using the firmware in your signature. I have tried firmwares from 2010 as well as the original firmware off the dlink site not sure what else can be done at this point?