ian5142
DD-WRT Guru
Joined: 23 Oct 2013
Posts: 2319
Location: Canada
|
 Posted: Thu Oct 04, 2018 2:48 Post subject: TFTP from router to PC |
 |
Is it possible to TFTP a file from the router to a computer?
I am trying to recover a Linksys EA6100 (not supported, I know). I have a second one that is working. Both have Serial access. I want to grab the working boot partition from one and transfer it to my PC, so I can flash it to the not working one.
PS, for those wondering. Yes, I have already tried flashing the factory firmware. It still says Bad Magic Number.
On the working router, running Linksys stock firmware, I can either do it from within the firmware (Linux based) or from U-boot which has very limited commands. U-boot does have the nand command but I can't figure out how to transfer data to a file that sits on the routers RAM so that I can then use TFTP. The "nand read" command only outputs a section of the flash to the serial console.
Any suggestions?
_________________
Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
QCA Best WiFi Settings
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one.
Atheros:
Netgear R7800 x3 - WDS AP / station, gateway, QoS
TP-Link Archer C7 v2 x2 - WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - NU
D-Link 615 C1/E3/I1 x 7 - 1 WDS station
D-Link 825 B1 - NU
D-Link 862L A1 x2 - WDS Station
Netgear WNDR3700v2 - NU
UBNT loco M2 x2 - airOS
Broadcom
Linksys EA6400 - Gateway, QoS
Asus N66U - AP
Netgear WNDR3700v3 - not used
MediaTek
UBNT EdgeRouter X - switch
|
|
