TP-Link WDR-4300: Only Wi-Fi is slow (Ethernet is fine)

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Atheros WiSOC based Hardware
Author Message
fuloyezih
DD-WRT Novice


Joined: 06 Jun 2018
Posts: 2

PostPosted: Wed Jun 06, 2018 6:01    Post subject: TP-Link WDR-4300: Only Wi-Fi is slow (Ethernet is fine) Reply with quote
I have searched Google a lot, but could not find a solution.

I have installed the latest beta. Let's say I have three computers: C1, C2, and C3. C1 and C2 are connected using Ethernet, and C3 is using Wi-Fi. When copying a file C1->C2, I get about 100MB/s. When C1->C3, I get about 10MB/s (5GHz) or 5MB/s (2.4GHz).

C3 is of course capable of 300Mbps (Intel Dual Band Wireless-AC 8265). The linked speed is shown as 300Mbps. But after changing the stock firmware to DD-WRT, the Wi-Fi speed got that slow.

I have not changed much from the default settings. What's wrong?

Mode: AP
Network: N-Only 5Ghz
Width : HT40 (also tried Dynamic or Full)
Channel: Auto
SEcurity: WPA2 Personal (also tried disabled)
Alg: AES

I have seen the Status page, and there is some strange thing:

MAC Address Interface Uptime TX Rate RX Rate Info Signal Noise SNR Signal Quality
mobile 1 ath1 0:11:45 72M 6M HT20SGI -41 -96 55 100%
mobile 2 ath1 0:29:11 58M 6M LEGACY -52 -96 44 96%
My C3 computer ath1 0:29:20 135M 300M HT40SGI -59 -96 37 82%
mobile 3 ath1 0:29:44 300M 24M HT40SGI -43 -96 53

All other devices have higher TX but the C3 computer had higher RX rate (its TX rate was 135M).
Sponsor
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Atheros WiSOC based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum