Everything went fine to point 5. ("Open your browser to http://192.168.1.1. A hard reset may leave you at a page titled MANAGEMENT MODE. If so, power cycle the router and reload. You should be in the Factory Setup GUI.")
Effectively, the router showed me the message "MANAGEMENT MODE". When I re-start the router, I can no longer access the WEB-GUI. 192.168.1.1 does not respond, the router has the ip 192.168.1.100 (I can do a PING to that address but nothing else. I can not access it with the browser, not with SSH)
Posted: Wed Apr 25, 2018 18:18 Post subject: DD-WRT
What is your plan with such an ancient device?
Don't expect amazing speeds from it. Don't even plan on using it for VPN (~1Mb/s).
I would suggest setting a static IP on your computer (192.168.1.60 for example) then try accessing the router at either 192.168.1.1 or 192.168.1.100. _________________ Before asking a question on the forums, update dd-wrt: Where do I download firmware? I suggest reading it all.
Some dd-wrt wiki pages are up to date, others are not. PM me if you find an old one, I am trying to update them.
TP-Link Archer C7 v2 x2 - WDS AP, WDS Station
TP-Link TL-WDR3600 v1 - WDS Station
TP-Link 841nd v8 - WDS Station
Linksys WRT400N - bricked
D-Link 615 C1 x 4 - not used
D-Link 615 E3 x 2 - WDS Station
D-Link 825 B1 - WDS Station
D-Link 862L A1 - WDS Station (Entware 3X)
Netgear WNDR3700v2 - WDS Station
TP-Link 1043nd v1, inactive, unstable hardware
UBNT loco M2 x2 - airOS
Asus N66U - backup Gateway
Netgear r6300 v1 - AP
Linksys E2500 - not used
Linksys EA2700 - not used
Linksys 160N v3 x2 - not used
Netgear WNDR3700v3 - not used
UBNT EdgeRouter X - Gateway, DHCP, QoS