New Build 4/19/18 - r35767

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.)
Goto page 1, 2  Next
Author Message
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1609
Location: SE Michigan USA

PostPosted: Thu Apr 19, 2018 19:17    Post subject: New Build 4/19/18 - r35767 Reply with quote
New build out.
ftp://ftp.dd-wrt.com/betas/2018/04-19-2018-r35767/

Template to copy (after "Code:") for posting a reply:
Code:
Router/Version:
Firmware:
Kernel:
Reset?/Mode:
Issues/Errors:

Update with good and bad experiences.

Doesn't anyone check for updates? I do not even use a WRT anymore, but last two builds I have been the one to post about a new build.

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Sponsor
CaperJoe
DD-WRT User


Joined: 30 Apr 2017
Posts: 51

PostPosted: Thu Apr 19, 2018 22:48    Post subject: WRT3200ACM-r35767?? Reply with quote
Upgraded but version number remained at 35681- guessing this version wasn't updated for WRT3200ACM. Checking the timeline there looks to be a few open tickets in regards to bootloops and unable to upgrade- I think I am going to revert back to 35681 which has been running great.
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1609
Location: SE Michigan USA

PostPosted: Fri Apr 20, 2018 0:29    Post subject: Re: WRT3200ACM-r35767?? Reply with quote
CaperJoe wrote:
Upgraded but version number remained at 35681- guessing this version wasn't updated for WRT3200ACM. Checking the timeline there looks to be a few open tickets in regards to bootloops and unable to upgrade- I think I am going to revert back to 35681 which has been running great.


Could be. Was updated for my Netgear r8000. Wink
Don't do wrt3200 anymore, in fact I sold it. Not the least be sorry I did.

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
d0ug
DD-WRT Guru


Joined: 31 Jul 2015
Posts: 794

PostPosted: Fri Apr 20, 2018 0:43    Post subject: Reply with quote
Yeah I think it is a bad build. Two of the WRT1200AC v2 that I flashed it to both still show r35681 after flashing and took a bit longer than usual to boot.

I can only assume it didn't like it and rebooted again to the previous partition on it's own.

*EDIT*

Confirmed it is auto booting back to the previous version.

I ran ubootenv get boot_part before and after trying to flash the new build

BEFORE

root@BEDRMAP:~# ubootenv get boot_part
a_pEnv->crc = db635c11
crc32 = db635c11
2

flashed and long boot time

AFTER

root@BEDRMAP:~# ubootenv get boot_part
a_pEnv->crc = db635c11
crc32 = db635c11
2

I don't partake in the sillyness of trying to keep the linksys partition intact. I just flash, so a successful flash should have put the new build on partition 1 and left my previous build on partition 2
pseudonym
DD-WRT Novice


Joined: 06 Jul 2017
Posts: 3

PostPosted: Fri Apr 20, 2018 1:04    Post subject: Reply with quote
d0ug wrote:
Yeah I think it is a bad build. Two of the WRT1200AC v2 that I flashed it to both still show r35681 after flashing and took a bit longer than usual to boot.



Same result on my WRT3200ACM.
slimbrick87
DD-WRT User


Joined: 10 Jul 2017
Posts: 92

PostPosted: Fri Apr 20, 2018 3:29    Post subject: Re: New Build 4/19/18 - r35767 Reply with quote
myersw wrote:


Doesn't anyone check for updates? I do not even use a WRT anymore, but last two builds I have been the one to post about a new build.


I've been a little nervous about updates lately. Everything was going very smoothly for me in DD-WRT land until r35667 when it all went south. Guess I should get back on the wagon and try.

_________________
FIRMWARE: 6-20-2018 - r36168
MODEM: ARRIS SURFBoard SB6183
ROUTER: Linksys WRT1900ACS V2
ISP: TWC Spectrum 100 Mbps Download | 10 Mbps Upload
SERVICES: IVPN OpenVPN Client
sonoranscout
DD-WRT Novice


Joined: 01 Jun 2017
Posts: 6

PostPosted: Fri Apr 20, 2018 4:04    Post subject: Reply with quote
Another confirmation of unsuccessful flash upgrade. Back to lede/openwrt (davidc502 snapshot). By far, the best wrt3200acm fw ever.
dance85
DD-WRT User


Joined: 02 Jun 2017
Posts: 172

PostPosted: Fri Apr 20, 2018 9:53    Post subject: Re: WRT3200ACM-r35767?? Reply with quote
CaperJoe wrote:
Upgraded but version number remained at 35681- guessing this version wasn't updated for WRT3200ACM. Checking the timeline there looks to be a few open tickets in regards to bootloops and unable to upgrade- I think I am going to revert back to 35681 which has been running great.



Same result on my WRT3200ACM-V2 and WRT1900ACS-V2
Buddlespit
DD-WRT Novice


Joined: 20 Sep 2013
Posts: 13
Location: Chesapeake, VA

PostPosted: Fri Apr 20, 2018 11:43    Post subject: Re: New Build 4/19/18 - r35767 Reply with quote
myersw wrote:
New build out.
<--SNIP-->
Doesn't anyone check for updates? I do not even use a WRT anymore, but last two builds I have been the one to post about a new build.


Not anymore. I was able to get my intranet working properly with r34578. I'm not upgrading it anymore. As far as I'm concerned, this router is EOL and will be replaced in a few months. I still continue to check the forum once a day, but there's no real point in screwing with this damned thing.
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1609
Location: SE Michigan USA

PostPosted: Fri Apr 20, 2018 13:48    Post subject: Reply with quote
@Buddlespit
Understand fully. No Linksys on my network anymore and there will not be what with the 3 years of frustration with the WRT's. Linksys is on my do not buy list.
My 2 Netgears work very well.

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
knacht
DD-WRT Novice


Joined: 20 May 2017
Posts: 31
Location: Bowling Green, Ohio

PostPosted: Fri Apr 20, 2018 15:58    Post subject: Reply with quote
#35681, has been up 11 days here.

Very modest load on the system, but its running very well...

_________________
WRT 3200 ACM Ver.1
BillyS
DD-WRT Novice


Joined: 19 Jan 2017
Posts: 17

PostPosted: Fri Apr 20, 2018 19:25    Post subject: Reply with quote
myersw wrote:
@Buddlespit
Understand fully. No Linksys on my network anymore and there will not be what with the 3 years of frustration with the WRT's. Linksys is on my do not buy list.
My 2 Netgears work very well.


Same here, I'm done with Linksys. I was just about to sell my WRT1900ACv1 when Linksys posted new firmware. If that doesn't work out, I'm going with Google WiFi or something similar. I need a company that will support a device when it's not working as intended and is willing to quickly patch problems. Personally, I'm shocked there was never a class action lawsuit.
adriansuri
DD-WRT Novice


Joined: 01 Oct 2017
Posts: 39

PostPosted: Sat Apr 21, 2018 13:17    Post subject: same here Reply with quote
While the update seemed to go well, it's build number didn't change and I have also lost my two drives attached in an Icy box via esata

is there a command tool to manually attach these, yes I know you have the mount command but that doesn't work if the drive is not in your /dev dir ......

Thanks in advance

Adrian Suri
slimbrick87
DD-WRT User


Joined: 10 Jul 2017
Posts: 92

PostPosted: Sat Apr 21, 2018 15:00    Post subject: Reply with quote
myersw wrote:
@Buddlespit
Understand fully. No Linksys on my network anymore and there will not be what with the 3 years of frustration with the WRT's. Linksys is on my do not buy list.
My 2 Netgears work very well.


If you don't mind, what were the three or four things that caused you frustration with the WRT's? I ask because I own one and haven't had problems. I'd consider changing routers if I have a better understanding of what I might be missing. Thanks.

_________________
FIRMWARE: 6-20-2018 - r36168
MODEM: ARRIS SURFBoard SB6183
ROUTER: Linksys WRT1900ACS V2
ISP: TWC Spectrum 100 Mbps Download | 10 Mbps Upload
SERVICES: IVPN OpenVPN Client
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1609
Location: SE Michigan USA

PostPosted: Sat Apr 21, 2018 23:07    Post subject: Reply with quote
slimbrick87 wrote:
If you don't mind, what were the three or four things that caused you frustration with the WRT's? I ask because I own one and haven't had problems. I'd consider changing routers if I have a better understanding of what I might be missing. Thanks.


Big thing is having a ready for DD-WRT statement on the box and not providing dd-wrt with decent wireless drivers and taking 2 years to get something that works most of the time and still missing wireless features. They are still working on the driver for the wrt3200 and it has been out for over 2 years. VERY POOR SUPPORT for a supposed ready for 3rd party firmware. I spent 3 years with wrt1900ac v1, wrt1900acs v1 and a wrt3200. If you read the forum you will read that there are still issues after being on the market for 2+ years.

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Goto page 1, 2  Next Display posts from previous:    Page 1 of 2
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.) All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum