Joined: 13 Jun 2006 Posts: 1609 Location: SE Michigan USA
Posted: Mon Apr 09, 2018 12:44 Post subject:
Factory to ddwrt is for flashing from the Linksys firmware UI. The webflash is for flashing from within the dd-wrt UI. Read the threads in my sig to understand this router, its two partitions, and lots of other good stuff. Had you read them you would not be asking this question as you would know.
By the way, since you flashed the factory to ddwrt and then then webflash, I assume from within dd-wrt UI you have overwritten both Linksys partitions.
--bill _________________ Unifi Security Gateway:Unifi Firmware Netgear r7800:Voxel Firmware Modem:Netgear CM500V voice and Data. ISP:Comcast tutorial for flashing "WRT" series: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813 DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117 Kong DD-WRT Config Tutorial: http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/ I tried to be normal once. Worst 2 minutes ever.