This build thread is for reporting successes and problem with loading this experimental test build. This is important info for developers and users. Always state your hardware and SPECIFIC build (e.g. dd-wrt.v24-K3_AC_ARM_STD.bin). Do not ask questions about your specific router or how to configure it in this thread; create your own thread to discuss any specific problems you have or need resolved. Please also do not respond to such questions. This thread is to report info, not to seek it. Posts that do not add to understanding this build will be deleted. Make sure you know how to flash properly and the risk before using this build. It is important to adhere to these requirements, to keep this thread from becoming impossibly long and useless.
If you don't know what build to flash and how to flash properly and have a means of recovery if things should go wrong, do NOT flash this experimental test build.
Router: Netgear AC1450
Prior Firmware: Netgear V126.96.36.199_1.0.4
Kernel: Linux 4.4.95 #472 SMP Fri Nov 3 23:27:37 CET 2017 armv7l
Reset: Factory reset from Netgear firmware, then overtake, then 10 seconds on button after flash
Errors: MAC address wrong
dd-wrt assigned duplicate MAC addresses to interface br0 and interface eth1. Corrected this by the following at the command line
root@DD-WRT:~# nvram get lan_hwaddr
root@DD-WRT:~# nvram get wl0_hwaddr
root@DD-WRT:~# nvram set lan_hwaddr=28:C6:8E:73:44:C5
root@DD-WRT:~# nvram commit
Other than that the interface is nice and snappy and the radio seems to work fine, will be doing further testing