[z4t01cH1]

Hi Guys.

I need help with my router Thomson Twg 870, use the Broadcom 3380 and FLA1 memory is Spansion FL064PIF and RAM is Samsung K4151163QJ. i connect the UART pin and data is show me this:

********************************************************
eCos - hal_diag_init
Init device '/dev/BrcmTelnetIoDriver'
Init device '/dev/ttydiag'
Init tty channel: 810b3d38
Init device '/dev/tty0'
Init tty channel: 810b3d58
Init device '/dev/haldiag'
HAL/diag SERIAL init
Init device '/dev/ser0'
BCM 33XX SERIAL init - dev: 0.2
Set output buffer - buf: 0x812a8570 len: 4096
Set input buffer - buf: 0x812a9570 len: 4096
BCM 33XX SERIAL config

Init device '/dev/ser1'
BCM 33XX SERIAL init - dev: 0.3
Set output buffer - buf: 0x812aa570 len: 4096
Set input buffer - buf: 0x812ab570 len: 4096
BCM 33XX SERIAL config

LsSpiInit 3380
Function: SetHardcodeVendorProfile
Battery Thread Constructor....
Leaving Battery thread constructor....
[Askey Debug]: No VP-24, use the default valus
mtaNvCalcChecksum: checksum= 1273036005
Reading Permanent settings from non-vol...
Checksum for permanent settings: 0x8a973f37
Setting downstream calibration signature to ''
Setting downstream calibration signature to ''

*
*
* One or more of the settings groups was missing, possibly as a result of a code upgrade.
*
*

*
*
* One or more of the settings groups was upgraded.
*
*
Settings were read and verified.


Reading Dynamic settings from non-vol...
Checksum for dynamic settings: 0x5f00baa2
Settings were read and verified.


------------------------------------
Free Pool Manager Configuration
---ChipHalSelectPinMux: Setting pin mux sel 18, word 0, value 2
ChipHalSelectPinMux: Setting pin mux sel 21, word 0, value 1
ChipHalSelectPinMux: Setting pin mux sel 13, word 0, value 0
---------------------------------
Buffer size in Bytes....Creating a new host MSG PROC DQM manager. Instance: 83eaba58, DQM_REGS = b8801800, CTRL_REGS = b8801000
Initializing main MSG_PROC DQM interrupts.
b8801000: 00000000
b8801004: 00000000
b8801008: 00000008
b880100c: 00000000
b8801010: 00000000
b8801014: 00000000
b8801018: 00000000
b880101c: 00000000
........... 2048
Number of TCreating a new host FAP DQM manager. Instance: 83eab9a4
Initializing main FAP DQM interrupts.
b8401000: 00000000
b8401004: 00000000
b8401008: 00000008
b840100c: 00000000
b8401010: 00000000
b8401014: 00000000
b8401018: 00000000
b840101c: 00000000
okens................... 8192
Base Address of FPM Memory ........ 0xb2010200
Base Address of FPM Mem in DDR2.... 0x82e50850

********************************************************

i dont know the next step to install DD WRT firmware, please help me or tell me if is possibly install a new ones.

Thx