Posted: Sat Nov 11, 2017 23:52 Post subject: Archer TP link c9 V3 bricked ?
639/5000
I apologize for my English.
I am looking for a help with my router, recently installed the ddwrt in its last available version (11-04-2017-r33679) and worked wonderfully well, until I decided to activate the radius server, which as a requirement it would be necessary to activate JFFS as well. so I did, now my router looks like a brick reacts to nothing, as soon as the WPS led is on.
model: tplink archer C9 v3
already tried to recover by the recovery mode that the manufacturer implanted
already tried the TFTP, nothing responds.
Please someone has a suggestion, I do not have advanced level, but with a good help I understand.
You will likely have to plug in a serial console and recover it that way.
You have a lot of reading to do. And probably you need to post to that thread once you get a terminal working on it. Make sure to report how it got bricked on that thread.
CFE version 6.37.14.93 (r469350) based on BBP 1.0.37 for BCM947XX (32bit,SP,)
Build Date: Wed Jan 13 15:52:58 UTC 2016 (leven@leven)
Copyright (C) 2000-2008 Broadcom Corporation.
Init Arena
Init Devs.
Boot partition size = 262144(0x40000)
DDR Clock: 800 MHz
Info: DDR frequency set from clkfreq=1000,*800*
et0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 6.37.14.93 (r469350)
CPU type 0x0: 1000MHz
Tot mem: 131072 KBytes
Device eth0: hwaddr 00-90-4C-11-20-01, ipaddr 192.168.1.1, mask 255.255.255.0
gateway not set, nameserver not set
Reading Partition Table from NVRAM ... OK
Parsing Partition Table ... OK
[NM_Error](nm_api_readPtnFromNvram) 00140: partition name not found.
[NM_Error](nm_api_checkInteger) 00331: factory boot check integer read flag partition fail.
Device eth0: hwaddr 00-90-4C-11-20-01, ipaddr 192.168.0.1, mask 255.255.255.0
gateway not set, nameserver not set
CFE>
Posted: Fri Jan 12, 2018 22:45 Post subject: Re: Archer TP link c9 V3 bricked ?
joaojp18 wrote:
639/5000
I apologize for my English.
I am looking for a help with my router, recently installed the ddwrt in its last available version (11-04-2017-r33679) and worked wonderfully well, until I decided to activate the radius server, which as a requirement it would be necessary to activate JFFS as well. so I did, now my router looks like a brick reacts to nothing, as soon as the WPS led is on.
model: tplink archer C9 v3
already tried to recover by the recovery mode that the manufacturer implanted
already tried the TFTP, nothing responds.
Please someone has a suggestion, I do not have advanced level, but with a good help I understand.
