working fine WDS STA on 2.4GHz
Guest VAP on 5GHz (some changes there)
Edit: after reading this post in Broadcom forum where
Router: Netgear r6400v1
Firmware: DD-WRT v3.0-r39855M kongac (05/25/19)
Errors: "SSH Management" under "Administration > Router Management" is disabled and grayed out, it cannot be enabled.
I checked all my routers and found the same to be true on this router with this build.
ssh managment is always greyed out. unless you enable ssh of course at the services tab
in addition its refering to kong builds. never report bugs from third party builds. they will be ignored _________________ "So you tried to use the computer and it started smoking? Sounds like a Mac to me.." - Louis Rossmann https://www.youtube.com/watch?v=eL_5YDRWqGE&t=60s
Posted: Wed Jun 26, 2019 12:58 Post subject: WR940v3 / WR941V6 isolated switch bports in AP Mode
I Have installed this version to the above mentioned router, flashing resetting and config went flawless, so first a big thank you for reuse of the ancient router. I'm using it as a AP connected to a router in the basement. Everything seems to work except the LAN ports are isolated to each other. Did I miss asetting or is that a feature or bug ? all settings seem fine and all the network devices seem to be on VLAN0 configured so I don't see my misconfig right now. between the WAN Port (joined the witch) downlink and the switch ports and WLAN works, only the 4 LAn Switch Ports are not able to communicate together. Can someone shed some light on that (Same behavior on the 39944) so I assume I make some mistake or it is hardware depending. Thanks
swconfig dev eth0 show
vid: 0 ports :0 1 2 3 4 whre port 0 seems to be the WAN port and the rest the switch ports