Posted: Sat Apr 08, 2017 22:01 Post subject: WRTAC1200 Dedicated Port
I would like to create a subnet and ssid (VLAN?) and a dedicated port on the router to be used to connect a TPLINK CPE210 Access Point.
The subnet will be used exclusively for the CPE210.
I was able to do this with a wrt54GS v7.2 router, however the dd-wrt for the wrtac1200 is different, and not being a network person am struggling (besides there are very explicit instructions/tutorials out there for the 54GS model of router)
Any help would be appreciated.
Joined: 14 Dec 2015 Posts: 730 Location: 127.0.0.1
Posted: Sat Apr 08, 2017 23:32 Post subject:
I would post this in the Advanced Networking forum, you should get an answer a lot quicker than in this forum. _________________ Tutorial for flashing WRT series WRT Installation,Upgrade & Basic Setup–Cliff Notes
DD-WRT Firmware: r42054: WRT3200ACM, WRT1200ACv1 (Smart crap subnet), WRT1900ACv1
Velop:3 WHW0101, RE6500, RE9000(AP)
TWC/Spectrum - 300/25
SysLog Watcher 5, Security Onion 2 on Virtual Box, Fingboxes, PiHoles