Joined: 16 Apr 2016 Posts: 307 Location: California
Posted: Wed Aug 21, 2019 7:15 Post subject:
You are using the wrong info, which means you ignored the very most important part of the first page of this thread, which you should probably read, because it is important. It means you copied a code that somebody else copied wrong. The command is actually.
Yes thanks - I originally cut and pasted the wrong code but corrected it in the command window. It still has the same issue where it does not seem to be able to run the script with the....
Joined: 16 Apr 2016 Posts: 307 Location: California
Posted: Wed Aug 21, 2019 7:44 Post subject: pasting
You arent pasting the word "code:" are you?
It only starts with "eval" _________________ My Karma ran over your Dogma
SploitWorks Custom Flashed Routers
Joined: 16 Apr 2016 Posts: 307 Location: California
Posted: Wed Aug 21, 2019 8:11 Post subject: The only time
The only time I have seen that is when someone was copying and pasting from Safari on a MAC OR they were trying to route through a failed install of the VPN on the router, meaning they were trying to use my script when they had already tried a bunch of other peoples crap.
Also, this can happen if your router doesnt have any internet / dns settings _________________ My Karma ran over your Dogma
SploitWorks Custom Flashed Routers
After fighting with this for two days, and countless chats with the PureVPN support team, still no dice. It was a hopeful breath of air when i found this thread!
I am extremely thankful for Sploit and eibgrad for taking the time to help.
It seems like i am having the same issue as Yokiebear.
I am about to do a factory reset and try again from scratch, (lost count!). and plan to meticulously follow the instructions.
I'm getting to the question.....
I have a Linksys E2100L with dd-WRT 3.0 build 40559.
It is installed behind the main router, but has it's own subnet. The router is connected to the internet, (i can browse whit a computer connected to it.
I have even disabled the firewalls on the main and secondary router.
You mentioned having the DNS set. Can I ask what DNS should be set to?
Joined: 18 Mar 2014 Posts: 12889 Location: Netherlands
Posted: Mon Aug 26, 2019 8:54 Post subject:
sheddo wrote:
I think it is 3.10.108-d8.
Does that make sense?
Yes, you can see it on the Status /Router page
So you are on K3.10 which should normally work.
Start a new thread in the Advanced Networing forum, state router model, build number, linux kernel and what instructions you followed.
Show pictures of the whole settings page and OVPN status page.
I read all the thread & have reset router still nothing from script im using linksys wrt1900acs v3.0r40559 build
router is onlinewhen I try
any ideas thnx
If you are using Linux K2.6 then it will not work.
YOu either have to use a build after 40708 or use linux Kernel 3
Got it working on K2.6:
When I run your eval command using ssh, I noticed that wget did not download the file.
So downloaded the wsi file to another PC, pasted the text in a file I locally created on the linksys e3000, chmod the file. And run it using eval ./file.wsi
