<5>[ 259.090000] sd 1:0:0:0: [sda] Attached SCSI removable disk
<4>[16861.430000] AG7240: unit 0: phy 0 not up carrier 1
<6>[16861.430000] br0: port 1(eth0) entered disabled state
<4>[45749.440000] AG7240: enet unit:0 is up...
<4>[45749.440000] Mii 100Mbps full duplex
<4>[45749.440000] AG7240: done cfg2 0x7115 ifctl 0x0 miictrl
<6>[45749.450000] br0: port 1(eth0) entered forwarding state
<6>[45749.450000] br0: port 1(eth0) entered forwarding state
<6>[45751.450000] br0: port 1(eth0) entered forwarding state
<6>[50735.570000] usb 1-1: USB disconnect, device number 3
<0>[50735.580000] switch USB LED Off
<0>[50741.570000] switch USB LED On
<6>[50741.570000] usb 1-1: new high-speed USB device number 4 using ar71xx-ehci
<6>[50741.730000] usb-storage 1-1:1.0: USB Mass Storage device detected
<6>[50741.750000] scsi2 : usb-storage 1-1:1.0
<5>[50742.750000] scsi 2:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6
<5>[50742.760000] sd 2:0:0:0: [sda] 60062500 512-byte logical blocks: (30.7 GB/28.6 GiB)
<5>[50742.770000] sd 2:0:0:0: [sda] Write Protect is off
<7>[50742.770000] sd 2:0:0:0: [sda] Mode Sense: 43 00 00 00
<5>[50742.780000] sd 2:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
<6>[50742.800000] sda: sda1
<5>[50742.810000] sd 2:0:0:0: [sda] Attached SCSI removable disk
mount:
Code:
/tmp# mount -o rw -t ext3 /dev/sda1 /tmp/usb
mount: mounting /dev/sda1 on /tmp/usb failed: No such device