Your reports for Marvell units are greatly appreciated !
Router:
Firmware:
Kernel:
Status:
Reset:
Errors:
This build thread is for reporting successes and problem with loading this experimental test build. This is important info for developers and users. Always state your hardware and SPECIFIC build. Do not ask questions about your specific router or how to configure it in this thread; create your own thread to discuss any specific problems you have or need resolved. Please also do not respond to such questions. This thread is to report info, not to seek it. Posts that do not add to understanding this build will be deleted. Make sure you know how to flash properly and the risk before using this build. It is important to adhere to these requirements, to keep this thread from becoming impossibly long and useless. If you don't know what build to flash and how to flash properly and have a means of recovery if things should go wrong, do NOT flash this experimental test build. _________________ THERE ARE NO STRANGERS HERE; ONLY FRIENDS YOU HAVEN'T YET MET.
________________________________________________________________________________________________________
DD-WRT CHANGELOG | DEVICES | DD-WRT BUILDS | KONG BUILDS | UNOFFICIAL BUILDS | DD-WRT in VIRTUALBOX
Joined: 13 Jun 2006 Posts: 1608 Location: SE Michigan USA
Posted: Fri Oct 28, 2016 17:42 Post subject:
Yemble wrote:
@myersw
How is this release with your WRT1900AC v1?
I skipped the last two releases due to the radio issue that you reported.
Still same 2.4GHz wireless issues as reported before. Cannot set mode, width, or channel number. Router is a wrt1900ac v1.
I did just install Kong 30800 and that build you can set the above with latest wireless driver, 10.3.2.0-20161011. Running Kong's build right now. Not up long enough to know of issues other then config.
Joined: 14 Dec 2015 Posts: 774 Location: 127.0.0.1
Posted: Sat Oct 29, 2016 22:20 Post subject:
myersw wrote:
Still same 2.4GHz wireless issues as reported before. Cannot set mode, width, or channel number. Router is a wrt1900ac v1.
I did just install Kong 30800 and that build you can set the above with latest wireless driver, 10.3.2.0-20161011. Running Kong's build right now. Not up long enough to know of issues other then config.
Joined: 13 Jun 2006 Posts: 1608 Location: SE Michigan USA
Posted: Sat Oct 29, 2016 23:48 Post subject:
ATHF wrote:
myersw wrote:
Still same 2.4GHz wireless issues as reported before. Cannot set mode, width, or channel number. Router is a wrt1900ac v1.
I did just install Kong 30800 and that build you can set the above with latest wireless driver, 10.3.2.0-20161011. Running Kong's build right now. Not up long enough to know of issues other then config.
It would look like it from reading the brief note. I did open a ticket for the issue so maybe he read that. Kong seems to have figured out the issue as his latest has the latest drivers and also can set the 2.4GHz wireless options unlike latest Brainslayer.
