Posted: Tue Sep 13, 2016 20:03 Post subject: Is my Linksys dead?
Hi, I've tried to load a ddwrt firmware on my Linksys wrt54g ver 6.0.
I followed this guide:
but probably something was wrong.
I followed all steps but when I tried the Tft software the attempts weren't enough to erase and to flash the firmware.
Accidentally I unplugged the charger and then I reinserted the charger and the router gave me the Remote Management but I don't know why I tried to unplugged one more time the charger and re-inserted it and now I can't reach the router's ip.
Now the power lamp blinks and if I try to hit a 30-30-30 Hard reset I have always the same outcome.
What do you suggest me?
Then see the peacock announcement, note 6. _________________ SIG:
I'm trying to teach you to fish, not give you a fish. If you just want a fish, wait for a fisherman who hands them out. I'm more of a fishing instructor.
LOM: "If you show that you have not bothered to read the forum announcements or to follow the advices in them then the level of help available for you will drop substantially, also known as Murrkf's law.."
Since I can reach the Remote Management page how can I do to flash the ddwrt firmware?
From which point of guide do I need to follow to get the ddwrt flashing?
From this point where I can access at Management page I've followed the guide from point 4 in Problem and Workaround to an inaccessible Linksys Wrt54g v6.0 router.
At point 6 and 7 I don't get "Upgrade Success" message.
Unlike of point 8 I can still get back to Management Mode.
Anyway I keep on to follow the steps but the power led didn'tstop blinking, etc. as has written in step 12.
Thanks my friend.
I followed the section of guide you suggested me and at 2 point, where you read you need to upload vxworks_prep_03.bin and My54gImage.bin files I can't get Upgrade success message. My router is stuck on Management page.
I tried to use the Tftp for 'dd-wrt.v24-12548_NEWD_micro' flashing but I can't get success (how long do I need to wait it?).
After the power cycle I come back into Management mode.
I don't understand about booting in tftp or without tftp as has written there.
How can I fix it?