WRT3200ACM??

Post new topic   This topic is locked: you cannot edit posts or make replies.    DD-WRT Forum Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.)
Goto page Previous  1, 2, 3 ... 146, 147, 148 ... 197, 198, 199  Next
Author Message
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1609
Location: SE Michigan USA

PostPosted: Thu Aug 17, 2017 2:55    Post subject: Reply with quote
kavok wrote:
So I ended up using 2017/08-03-2017-r33006/linksys-wrt3200acm/ddwrt-linksys-wrt3200acm-webflash.bin on my WRT3200ACM because when I tried factory-to-ddwrt.bin it gave me an error message about it not being the right full type or something.

Now the router is just flashing the power light. No wifi networks are visible and plugging into the LAN ports doesn't grab and IP from DHCP. Is the router hosed? How do I recover from this?


Please read the thread in my sig especially the second entry if you have not read this already. In there is how to switch back to the other partition. You need to understand the 2 partition thing before doing much.

It sounds like you used the wrong file to flash. If you were flashing from the Linksys UI you should have used the factory-to-ddwrt.bin file. The webflash is for upgrading from within the DD-WRT UI.

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Sponsor
LookingForMyMojo
DD-WRT Guru


Joined: 29 Aug 2014
Posts: 693

PostPosted: Fri Aug 18, 2017 17:28    Post subject: Reply with quote
This is just my opinion.

I have run the gambit for images on my 3200.
Including compiling my own LEDE(which is a hoot!), but nonetheless the result is always the same. LEDE for me after 3-4 days, just bogs down and annoyingly slow(with or without adblocking).

I am back on DDWRT's latest for my "WRT's", as it consistently performs well, for days on end. LEDE is great for the first 2 days. I bridge to the 3200 5ghz band, and DDWRT holds the connection, after 2 days, LEDE drops it.

Looking forward to the next BS release.

_________________
My "WRT" rant, and why I have gone ddwrt on x86, no more consumer routers. ( ac86u as access points & bridges )

https://www.dd-wrt.com/phpBB2/viewtopic.php?t=312142&highlight=ac86u
Dariusz
DD-WRT Novice


Joined: 15 May 2017
Posts: 18

PostPosted: Fri Aug 18, 2017 18:01    Post subject: Reply with quote
Hey guys, awesome topic!

QUick question I have r32670 and I'm experiencing quite a bit of issues, Could any1 reccoment the next stable version I could try?

Regards
Dariusz
LookingForMyMojo
DD-WRT Guru


Joined: 29 Aug 2014
Posts: 693

PostPosted: Sat Aug 19, 2017 15:09    Post subject: Reply with quote
Just try the last image from Aug 3
_________________
My "WRT" rant, and why I have gone ddwrt on x86, no more consumer routers. ( ac86u as access points & bridges )

https://www.dd-wrt.com/phpBB2/viewtopic.php?t=312142&highlight=ac86u
panoramarts
DD-WRT Novice


Joined: 23 Jun 2009
Posts: 3

PostPosted: Sun Aug 20, 2017 5:53    Post subject: Reply with quote
I am using 08-03-2017-r33006 latest build and I have encountered two bricking (power led flashing) had two reset to stock by holding reset and ON/OFF power switch four times to revert it. Anybody encountering this problem?
aairon
DD-WRT Guru


Joined: 18 Aug 2009
Posts: 597
Location: Antigua/Seattle

PostPosted: Sun Aug 20, 2017 12:44    Post subject: Reply with quote
panoramarts wrote:
I am using 08-03-2017-r33006 latest build and I have encountered two bricking (power led flashing) had two reset to stock by holding reset and ON/OFF power switch four times to revert it. Anybody encountering this problem?



As far as I can tell there is NO version of DD-WRT for WRT3200ACM that doesn't exhibit some " reset, loss of 5GHZ , loss of wifi authentication, and various things" UNDER CERTAIN circumstances.

Many people may find that in their particular case that some version of the DD-WRT firmware works fine for them.
The only way you will have any idea which version might work in your particular situation will be to do an incredible amount of reading and eventually try a lot of versions.

Since very high traffic on 5Ghz is super important for me NONE of the DD-WRT versions will work for more then half a day before my 5 Ghz clients will no longer be able to be authenticated. I am using LEDE right now.

I learned a lot of computer languages back in the late 60's and early 70's and no longer have the ambition to take up linux.

As a result I can safely say that the LEDE firmware "UI" is the most user hostile interface I've ever had the displeasure to deal with and the only way to make it close to DD-WRT in features is to learn about linux and figure out a way to add functionality.

For me when DD-WRT works for everything I need, it's like the clouds have parted...... Sol is shining brightly and warmly on my face, I hear birds singing, I smell fresh grass and trees and flowers, I hear children playing and laughing, and I know everything is good in the world.

I've pretty much have decided at this point to go back to the "Linksys/Belkin" firmware (even this may prove futile as the "STOCK" firmware is reporting 5Ghz drops) until BS gets some more time if he decides to keep plugging away at this headache.
I wouldn't blame him if he decides to stop further work on this, since the folks he has to get information from, will not give freely.
Good luck in your case you may find the last unofficial version will work for you.

P.S. My issues on 5 Ghz may be due to a poor choice of channels combined with (DD-WRT) radar detect needing to switch channels, may be causing the loss of authentication, I will try different 5 Ghz AP Channel and start test on last test version.


Last edited by aairon on Sun Aug 20, 2017 14:35; edited 2 times in total
Dariusz
DD-WRT Novice


Joined: 15 May 2017
Posts: 18

PostPosted: Sun Aug 20, 2017 13:33    Post subject: Reply with quote
LookingForMyMojo wrote:
Just try the last image from Aug 3


Will do but from where? Last 2 versions I got from post on forum...
aairon
DD-WRT Guru


Joined: 18 Aug 2009
Posts: 597
Location: Antigua/Seattle

PostPosted: Sun Aug 20, 2017 13:44    Post subject: Reply with quote
Dariusz wrote:
LookingForMyMojo wrote:
Just try the last image from Aug 3


Will do but from where? Last 2 versions I got from post on forum...


http://www.dd-wrt.com/site/support/other-downloads
LookingForMyMojo
DD-WRT Guru


Joined: 29 Aug 2014
Posts: 693

PostPosted: Sun Aug 20, 2017 15:25    Post subject: Reply with quote
aairon wrote:
Dariusz wrote:
LookingForMyMojo wrote:
Just try the last image from Aug 3


Will do but from where? Last 2 versions I got from post on forum...


http://www.dd-wrt.com/site/support/other-downloads


or : https://download1.dd-wrt.com/dd-wrtv2/downloads/betas/2017/

_________________
My "WRT" rant, and why I have gone ddwrt on x86, no more consumer routers. ( ac86u as access points & bridges )

https://www.dd-wrt.com/phpBB2/viewtopic.php?t=312142&highlight=ac86u
gufus
DD-WRT Guru


Joined: 04 Aug 2012
Posts: 612
Location: behind the screen

PostPosted: Sun Aug 20, 2017 19:47    Post subject: Reply with quote
Dariusz wrote:
LookingForMyMojo wrote:
Just try the last image from Aug 3


Will do but from where? Last 2 versions I got from post on forum...


Thats all you get, what BS posts here or the public betas.

_________________
WRT3200ACM openwrt 18.06.5
WRT3200ACM dd-wrt r41791
WRT54GL dd-wrt r21676
LookingForMyMojo
DD-WRT Guru


Joined: 29 Aug 2014
Posts: 693

PostPosted: Sun Aug 20, 2017 20:28    Post subject: Reply with quote
@aairon

LEDE is as easy as DDWRT to use if a person just reads a little.

_________________
My "WRT" rant, and why I have gone ddwrt on x86, no more consumer routers. ( ac86u as access points & bridges )

https://www.dd-wrt.com/phpBB2/viewtopic.php?t=312142&highlight=ac86u
gufus
DD-WRT Guru


Joined: 04 Aug 2012
Posts: 612
Location: behind the screen

PostPosted: Sun Aug 20, 2017 20:31    Post subject: Reply with quote
LookingForMyMojo wrote:
@aairon

LEDE is as easy as DDWRT to use if a person just reads a little.
VBG
_________________
WRT3200ACM openwrt 18.06.5
WRT3200ACM dd-wrt r41791
WRT54GL dd-wrt r21676
aairon
DD-WRT Guru


Joined: 18 Aug 2009
Posts: 597
Location: Antigua/Seattle

PostPosted: Sun Aug 20, 2017 22:06    Post subject: Reply with quote
LookingForMyMojo wrote:
@aairon

LEDE is as easy as DDWRT to use if a person just reads a little.


Right so DD-WRT is redundant?
Maybe you should convince BS of that. Smile

Fortran is just as easy as cobol if a person just reads a little. makes total sense too me.

By The Way, Lest You Forget we are on a Forum called

DD-WRT!
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1609
Location: SE Michigan USA

PostPosted: Sun Aug 20, 2017 23:44    Post subject: Reply with quote
aairon wrote:
LookingForMyMojo wrote:
@aairon

LEDE is as easy as DDWRT to use if a person just reads a little.


Right so DD-WRT is redundant?
Maybe you should convince BS of that. Smile

Fortran is just as easy as cobol if a person just reads a little. makes total sense too me.

By The Way, Lest You Forget we are on a Forum called

DD-WRT!

Good point. This forum does get off into the weeds at times. Have been guilty of that my self at times. Very Happy

We owe BS a lot of gratitude for sticking with this from the dark ages of the wrt54g.

_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
ATHF
DD-WRT Guru


Joined: 14 Dec 2015
Posts: 728
Location: 127.0.0.1

PostPosted: Mon Aug 21, 2017 2:10    Post subject: Reply with quote
aairon wrote:

Fortran is just as easy as cobol if a person just reads a little. makes total sense too me.


Sorry, I just had to bust this out tonight and reminisce!

_________________
Tutorial for flashing WRT series
WRT Installation,Upgrade & Basic Setup–Cliff Notes
DD-WRT Firmware: r42054: WRT3200ACM, WRT1200ACv1 (Smart crap subnet), WRT1900ACv1
Velop:3 WHW0101, RE6500, RE9000(AP)
TWC/Spectrum - 300/25
SysLog Watcher 5, Security Onion on Virtual Box, Fingboxes, PiHoles
Goto page Previous  1, 2, 3 ... 146, 147, 148 ... 197, 198, 199  Next Display posts from previous:    Page 147 of 199
Post new topic   This topic is locked: you cannot edit posts or make replies.    DD-WRT Forum Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.) All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum