Your reports for Broadcom units are greatly appreciated !
This build thread is for reporting successes and problem with loading this experimental test build. This is important info for developers and users. Always state your hardware and SPECIFIC build (e.g. 29440_NEWD-2_K2.6_mega-nv64k.bin). Do not ask questions about your specific router or how to configure it in this thread; create your own thread to discuss any specific problems you have or need resolved. Please also do not respond to such questions. This thread is to report info, not to seek it. Posts that do not add to understanding this build will be deleted. Make sure you know how to flash properly and the risk before using this build. It is important to adhere to these requirements, to keep this thread from becoming impossibly long and useless. If you don't know what build to flash and how to flash properly and have a means of recovery if things should go wrong, do NOT flash this experimental test build.
Last edited by recall8780 on Tue Aug 23, 2016 10:51; edited 1 time in total
First reboot after a bit more than 5 hours.
Was the same with previous build.
Also had to play with wireless at the beginning but went smooth after for almost 7 days.
So will probably be the same with this one...
Router: Linksys EA6700
Firmware: DD-WRT v3.0-r30465M
Kernel: Linux 4.4.19 #77 SMP Tue Aug 23 11:55:44 CEST 2016 armv7l
Status: Upgraded from Telnet. No errors or disconnect.
Max 72 Mbps on 2.4 N-G mixed
Max 72 Mbps on 2.4 N only
Max 150 Mbps on 5Ghz AC-N mixed
Max 600 Mbps on 5Ghz AC only
root@AP:~# ddup --flash-latest
wget: bad address 'www.desipro.de'
I also experienced this problem. I just flashed via web interface.
Can anybody here confirm if Privoxy in transparent mode is causing havoc on your network?
It is a beta version in the new 4.4 kernel.
Please post if you are also experiencing issues with Privoxy.
-Masterman _________________ Optware, the Right Way
Asus RT-N16 x5