bridge multiple ethernet intefaces not working

Post new topic   Reply to topic    DD-WRT Forum Forum Index -> X86 based Hardware
Author Message
J Wu
DD-WRT Novice


Joined: 05 Jun 2016
Posts: 1

PostPosted: Sun Jun 05, 2016 6:11    Post subject: bridge multiple ethernet intefaces not working Reply with quote
I need some help as I've run out of paths to investigate.

I have a 4 port Ethernet card, I was setting up ddwrt x86 to work with. 1 port as the WAN and the other 3 as LAN ports. Its running in Hyper-V.

However, no matter how I configure the bridge for the LAN only the lowest numbered LAN port seems to work. The other two ports don't DHCP or forward packets.

I was able to identify that the ports are seen by the ddwrt with the "brctl showmacs" command. Connected hosts show up on the list on the correct ports but they cannot communicate.

all the interfaces are "UP" with the "ifconfig" command, and they all are "forwarding" as shown with the brctl showstp.

What else should I check. thanks in advance
Sponsor
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Forum Index -> X86 based Hardware All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum