Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Kernel: Linux 3.10.101
Status: OK
Reset: NO
Errors:Router LEDs not working properly: Wifi 5.0GHz off, WPS always on, system off.
Joined: 25 Dec 2010 Posts: 295 Location: Twin Cities, MN
Posted: Thu May 19, 2016 12:07 Post subject:
Router: R7800
Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Kernel: Linux 3.18.33 #76 SMP PREEMPT Tue May 17 23:42:47 CEST 2016
Status: ok
Reset: no
Errors: ipv6 doesnt work correctly..router/devices acquire ipv6 correctly, but cant go anywhere on internet..
temp fix to get ipv6 working: ifconfig eth0 promisc _________________ NETGEAR R9000 | RT | 40134 NETGEAR R7800 | AP | 40134
Last edited by NiTrus on Fri May 20, 2016 0:33; edited 1 time in total
Router: DIR-600 B2
Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Kernel: Linux 3.2.80 #24103 Thu May 19 08:23:56 CEST 2016 mips
Status: DHCP working, DNS working, can't load web pages, wget not working, can't ping external servers (Using Client mode). Rolled back to r29519 and everything is working fine.
Reset: no
Errors: Client mode not working properly, (only DNS is working).
WNDR3700v4
DD-WRT v3.0-r29739 std (05/19/16)
Linux 3.18.33 #12161 Thu May 19 03:29:37 CEST 2016 mips
No Reset, main router, previous ¬
DD-WRT v3.0-r29721 std (05/18/16)
Linux 3.18.33 #12070 Wed May 18 04:13:52 CEST 2016 mip
All Ok tis far - uptime 1:33
-----
E2100L
DD-WRT v3.0-r29739 std (05/19/16)
Linux 3.10.101 #23000 Thu May 19 02:17:24 CEST 2016 mips
No Reset, in Client Mode, previous ¬
DD-WRT v3.0-r29621 std (05/10/16)
Linux 3.10.101 #22397 Tue May 10 04:22:34 CEST 2016 mips
Wired and wireless (on the VAP) all ok.
Client connected to main router guest network.
uptime 1:16
Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Kernel: Linux 3.10.101
Status: OK
Reset: NO
Errors:Router LEDs not working properly: Wifi 5.0GHz off, WPS always on, system off.
Router: TP-Link TL-WR841ND v7
Firmware: Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Reset: no
Errors: no
Status: "WIDE HT40" 6 + 2 (2437 MHz) just lasts for some minutes, then every client are back to HT20 again
Given there are no release notes yet, why was 5/19 released if 5/18 was greeted with such success?
Please use release numbers.
It's not impossible for there to be two releases on the same day. Especially if you include specials not publicly released.
Last edited by bdg2 on Fri May 20, 2016 0:47; edited 1 time in total
Router: TP-Link ARCHER-C7 v2
Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Reset: no
Errors: no
Status: yep!
All fine at the moment, no problems and no benefits
That's actually a good point to raise...
If a build doesn't fix a security issue, or a function that you need that isn't working, is there a benefit to upgrading.
There's probably a couple builds people could skip from time to time but there is seldom a new build that doesnt update something of core value (kernel, busybox, ssh, etc). They don't just push updates to say, fix one routers LED's. Something that minor is generally bundled in with the rest.
Router: DIR-862L
Firmware: DD-WRT v3.0-r29739 std (05/19/16)
Kernel: Linux 3.10.101
Status: cannot access web gui, router is acting like dmz is enabled will only only give connectivity via wifi, no lan ports working
Reset: YES
Errors: