After installing DD-WRT router will not start

Post new topic   Reply to topic    DD-WRT Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.)
View previous topic :: View next topic  
Author Message
diaconuliviu85
DD-WRT Novice


Joined: 17 Jun 2014
Posts: 19
PostPosted: Wed Dec 30, 2015 19:34    Post subject: After installing DD-WRT router will not start Reply with quote
Hello

At the moment we OpenWRT, but are not satisfied, wifi has big problems.
3 weeks ago I put ddwrt. It went right until I did a version update. After the update has not started. I had to do TTL flash by, and return to stock. then you can put OpenWRT, or stock but can not install ddwrt.
As soon as I install ddwrt by "WebGui" in stock or OpenWRT. The router restarts but does not start. What can I do to go to the DD-WRT?

mtd:
Could not open mtd device: linux
Can't open device for writing!

edit:
router : Linsys Wrt1900acs
Back to top View user's profile Send private message
Sponsor
Per Yngve Berg
DD-WRT Guru


Joined: 13 Aug 2013
Posts: 6868
Location: Romerike, Norway
PostPosted: Wed Dec 30, 2015 20:40    Post subject: Reply with quote
What Build did you try?
Back to top View user's profile Send private message
diaconuliviu85
DD-WRT Novice


Joined: 17 Jun 2014
Posts: 19
PostPosted: Wed Dec 30, 2015 20:58    Post subject: Reply with quote
I tried last 3 versions and will not start.

the latest version of DD-WRT, I tried flash, the TTL.
but the router remains dead.
"setenv serverip 192.168.1.2"
"setenv firmwareName ddwrt.img"?
"run update_both_images"
"reset"
Back to top View user's profile Send private message
Per Yngve Berg
DD-WRT Guru


Joined: 13 Aug 2013
Posts: 6868
Location: Romerike, Norway
PostPosted: Wed Dec 30, 2015 23:06    Post subject: Reply with quote
Have you tried 28397?

http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287757
Back to top View user's profile Send private message
diaconuliviu85
DD-WRT Novice


Joined: 17 Jun 2014
Posts: 19
PostPosted: Thu Dec 31, 2015 11:38    Post subject: Reply with quote
the question is how can I put DD-WRT?

this: 12-24-2015-r28598
Back to top View user's profile Send private message
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1608
Location: SE Michigan USA
PostPosted: Thu Dec 31, 2015 16:39    Post subject: Reply with quote
So is this the same router you said you could not recover in this thread?

http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287764&sid=2d4ff6c919165e3a262070a27cf28a75

If so what did you do to recover as you indicated you were not having any luck.

As for getting this working I am not sure where you are currently. What I would try for is getting the Linksys firmware on it and then only flashing from the Linksys partition. That gives you a known safe place should you have a firmware install go bad. This is how I do it and have not ever had any issues that could not be recovered with the reset 3 on/off cycles. When I update to a newer version of DD-WRT I switch to the Linksys partition and grab the .img file not the .bin.

--bill
_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Back to top View user's profile Send private message
myersw
DD-WRT Guru


Joined: 13 Jun 2006
Posts: 1608
Location: SE Michigan USA
PostPosted: Thu Dec 31, 2015 16:43    Post subject: Reply with quote
diaconuliviu85 wrote:
the question is how can I put DD-WRT?

this: 12-24-2015-r28598


I think there have been issues with r28598. I would install Kong's 28575. Kong tests his builds on the wrt1900's before posting. Brainslayer supports too many routers to test each one before posting, therefore it is always a risk when you install a Brainslayer build. Not a slam against Brainslayer just reality.

You can find Kong's latest at:

http://desipro.de/ddwrt/K3-AC-MVEBU/

--bill
_________________
Unifi Security Gateway: Unifi Firmware
Netgear r7800: Voxel Firmware
Modem:Netgear CM500V voice and Data.
ISP:Comcast
tutorial for flashing "WRT" series:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=287813
DD-WRT Installation, Upgrade & Basic Setup–Cliff Notes:
http://www.dd-wrt.com/phpBB2/viewtopic.php?t=311117
Kong DD-WRT Config Tutorial:
http://www.instructables.com/id/Install-and-Configure-a-DD-WRT-Kong-Router/
I tried to be normal once. Worst 2 minutes ever.
Back to top View user's profile Send private message
diaconuliviu85
DD-WRT Novice


Joined: 17 Jun 2014
Posts: 19
PostPosted: Sun Jan 03, 2016 15:43    Post subject: Reply with quote
Yes Kong's is working fine.
The latest oficial ddwrt from 2/1/2016 is not work.
Back to top View user's profile Send private message
diaconuliviu85
DD-WRT Novice


Joined: 17 Jun 2014
Posts: 19
PostPosted: Sun Jan 03, 2016 17:50    Post subject: Reply with quote
Where should I report this problem? to settle the future?
Back to top View user's profile Send private message
Per Yngve Berg
DD-WRT Guru


Joined: 13 Aug 2013
Posts: 6868
Location: Romerike, Norway
PostPosted: Sun Jan 03, 2016 18:09    Post subject: Reply with quote
Have you posted it in the Build Thread?
Back to top View user's profile Send private message
diaconuliviu85
DD-WRT Novice


Joined: 17 Jun 2014
Posts: 19
PostPosted: Sun Jan 03, 2016 18:53    Post subject: Reply with quote
NO
Back to top View user's profile Send private message
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Marvell MVEBU based Hardware (WRT1900AC etc.) All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum