Posted: Thu Jan 09, 2014 5:17 Post subject: Safely opening the housing of a WRT600N wireless router
I hate to open a new thread for this (very basic subject), but, my high school students have successfully detached the central rectangular antenna from this router. The repair seems simple other than I need to open the case in order to get some slack for the antenna wires in order to re-solder them. I'd like not to damage the housing, but have had only a short time examining how it's put together and wasn't able to see how to open it easily. My real question is: what's the best way to open the router up without damaging it so that we can put it back together once I reconnect the antenna wires?
Joined: 06 Jun 2006 Posts: 6852 Location: Dresden, Germany
Posted: Thu Jan 09, 2014 12:20 Post subject:
remove the screws beyond the device and then just open it. you cannot really damage something on it. you need some pressure on your finger nails while opening, but its just plastic. _________________ one cigarette costs 2 minutes of your life.
one bottle of beer costs 4 minutes of your life.
one working day costs 8 hours of your life.
Linux DD-WRT 4.14.8 #42 SMP PREEMPT Thu Dec 21 18:11:16 CET 2017 armv7l DD-WRT
root@DD-WRT:/sys# nvram get DD_BOARD
remove the screws beyond the device and then just open it. you cannot really damage something on it. you need some pressure on your finger nails while opening, but its just plastic.
Thanks Brian, I've been pouring over the forums for info on this router. I have wondered about the Broadcom chips and seems only breaking into the case will lend any positive identification.
I have been assuming it has the BCM4785 ver2 because of DD-WRT v24-sp2 mega 08/12/10 CLI response
root@DD-WRT:~# cat /proc/cpuinfo
system type : Broadcom BCM4785 chip rev 2
processor : 0
cpu model : BCM3302 V1.10
Still investigate separating a gig Ethernet port into a separate vlan or/and looking for a way to separate mgnt vlan from a single wired user, while still providing that user gateway service from wan. I get confusing info about the switch chipset i.e., BCM 5397, or BCM 5395 (I have thought it was actually a BCM53115)