Your reports for Marvell MVEBU units are greatly appreciated !
Router:
Firmware:
Kernel:
Status:
Reset:
Errors:
This build thread is for reporting successes and problem with loading this experimental test build. This is important info for developers and users. Always state your hardware and SPECIFIC build (e.g. 28548_NEWD-2_K2.6_mega-nv64k.bin). Do not ask questions about your specific router or how to configure it in this thread; create your own thread to discuss any specific problems you have or need resolved. Please also do not respond to such questions. This thread is to report info, not to seek it. Posts that do not add to understanding this build will be deleted. Make sure you know how to flash properly and the risk before using this build. It is important to adhere to these requirements, to keep this thread from becoming impossibly long and useless. If you don't know what build to flash and how to flash properly and have a means of recovery if things should go wrong, do NOT flash this experimental test build.
Last edited by GreyDoc on Sun Dec 20, 2015 6:19; edited 1 time in total
Flashed about 2 hours ago. Would have done factory reset because of new wireless driver, except my WRT1900AC dd-wrt flashes come up already reset to factory defaults for some reason.
Doing great, no problems yet. The new wireless driver (.15) is looking better than the old one from build 28500. Ping times are lower than they were with the previous wireless driver, while wireless coverage and strength is about the same.
Keep in mind that I use only the basic router functions, routing and wireless (plus IPv6), but this build looks really good so far.