NathanBasanese DD-WRT Novice
Joined: 18 Jul 2015 Posts: 7
|
Posted: Sat Jul 18, 2015 19:37 Post subject: // , WNDRMACv2 "Client Mode (Routed)" DD-WRT build |
|
// , I successfully flashed my NETGEAR WNDRMACv2 firmware from the NETGEAR V1.0.0.20 firmware to DD-WRT build 22118, using the NETGEAR V1.0.0.20 "Firmware update" webui.
To get DD-WRT build 22118 on my WNDRMACv2, I used instructions at the following forum post:
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=909794
I have followed the instructions here, as follows, to set this DD-WRT router up as a repeater:
http://www.dd-wrt.com/wiki/index.php/Client_Bridge
However, I'm having a bit of difficulty setting up my WNDRMACv2 as a repeater, since certain options in the Firewall section are grayed.
How can I check whether my WNDRMACv2 is working as a repeater?
What options for troubleshooting do I have?
Can anyone recommend any other way for me to use this router to extend my current network's range?
Is there anything specific I can add to this post?
Further Reading:
http://www.dd-wrt.com/phpBB2/viewtopic.php?p=909794 |
|