I have probably the same issue with WR841ND v9. So glad I bumped into this topic! Gonna check the solution soon while y'all say a script works like a charm. The ticket I created: http://svn.dd-wrt.com/ticket/6055
EDIT: It does work like a charm!
Last edited by Coolidge on Wed Apr 18, 2018 18:44; edited 1 time in total
I was running Firmware: DD-WRT v3.0-r30949 std (12/15/16) on TP-Link TL-WR841N v9 this script:
swconfig dev eth0 set enable_vlan 1
swconfig dev eth0 set apply
was working fine all the past years .
Now i update the firmware to DD-WRT v3.0-r38240 std (01/08/19) it doesn't work any more.
would you please help me with the right script that work with last DD-WRT version as i am not advanced user in DD-WRT?
The necessity could be an earlier version of DD-WRT that supports your hardware, such as: 27506, 27745, 31899, 33006, 33555, 35034, 35831, 35874, 35927, 36006, 36330. See also https://svn.dd-wrt.com/ _________________ Broadcom:
WNR3500Lv2 DD-WRT 33525 K3 Giga
3 R6300.1 mips DD-WRT 42617 Giga
E3000 5ghz multicast AP Toastman 2017 RT
E2000 5ghz multicast AP DD-WRT 33525 K2.6
WRT54GSv2 long range AP HyperWRT 15
R6250 (retired--too hot)
Archer C7v2 AP DD-WRT 35831
DIR-835 Gargoyle 1.11 2019
3 WR841Nv9 AP DD-WRT 33006
Hello, maybe you could try this as startup command :
swconfig dev switch0 set reset 1
swconfig dev switch0 set enable_vlan 1
swconfig dev switch0 set apply
Thanks for this, life-saver!
Current F/W release for TL-WR841N v11.1 (v3.0-r37305 std) has the same issue. I think this should be defaulted and the WebGUI could allow for control over it, but definetely should be default.