[^Albe^]

hi to all
i have just soldered a microsd adapter to my wrt54gsv4/latest v24rc5 std
the dd-wrt recognize it like a 3,136.00 KB / 0 (the microsd is a 512mb one)

well, looking from the upper (component side) front i have soldered:

the right pin of the dmz led (GPIO1?)=sd1-CS
the right pin of the left led ahead the switch (GPIO2?)=sd2-D1
Pin9 of the jp2 connector=sd3/6-GND
Pin 1 of the jp2 connector=sd4-V+
the rght pin of the right led ahead the switch (GPIO3?)=sd5-CLK
the right pin of the switch (GPIO4?)= sd7-D0
are that true?

the photo seems not clear (the one i have found)

i have tryed to configure manually the gpio and in auto mode, but nothing change
any help i well apreciated
regards and happy christmas

[RolF]

http://www.melilla500.com/WRT54_KARIOTA.JPG



R.

[^Albe^]

thx for the help
the sd2 and sd5 was swapped
but the sd does not recognized correctly
perhaps is a unlucky sd, all removed for the moment

must it work in auto mode or the gpio must be manually inserted?

[RolF]

I don't have 54Gv4 , but if you want auto then use 2,4,3,7 gpio :

case ROUTER_WRT54G:
if (nvram_match ("boardtype", "0x0467")) //v4 or GL
mmc_di = 2;
else
mmc_di = 5;
mmc_do = 4;
mmc_clk = 3;
mmc_cs = 7;
break;


R.