[yonu]

I am a bit confused I have a working pptp server working on a E3200 however I setup the client options in my wrt300n to connect to it. The best I can tell is that it isn't connecting at least it isn't showing as a pptp connection on the E3200 is there a way to know what is going on so that I atleast know if it is trying to connect?

Thanks,
Yonu

[Slater1601]

From the GUI you can go to the Administration > Commands tab and run the IFCONFIG command. If you have an established PPTP session it will show up with the two connected endpoints.

[yonu]

thanks didn't even think of that will give it a shot when I get back in front of it

[yonu]

ok I ran ifconfig but I get nothing about the pptp only the lan connections what should I check next to see why it isn't connecting?

[yonu]

I found the options.vpn file in the tmp folder however I am not sure if there is anything here that is the problem or not perhaps someone that is more knowledgeable could have a look at it.


defaultroute
lock
noauth
nodetach
refuse-eap
lcp-echo-failure 3
lcp-echo-interval 2
persist
usepeerdns
idle 0
ip-up-script /tmp/pptpd_client/ip-up
ip-down-script /tmp/pptpd_client/ip-down
ipparam kelokepptpd
mppe required
mtu 1450
mru 1450
name Beach
password lewis413
~
~
~
~
~
- options.vpn 1/18 5%

Thanka,
yonu

[yonu]

I totally forgot the build is

DD-WRT v24-sp2 (10/10/09) mega - build 13064

[yonu]

I take it there is no solution to this issue or no one knows of one.

Thanks,
Yonu