[JF]

Is there any way of forcing the radio to do not scan channels and start in 40 Mhz mode (HT 40)?

I need to conduct some test at home and I do need to know for sure that the radio in my router is in HT 40 mode.

My router is a TP-Link TL-wr1043ND running DD-WRT v24-sp2 std revision 20119.

Thanks in advance.
Regards

[Sash]

upgrade 1st and use turbo

[JF]

Thanks for your answer.
I just downgraded from r20675.
Either one or the other release I am not able to see the 40 Mhz activated.
Probably something in 2.4 Gzhz spectrum is interfering with the radio chip and activating good neighbour policy.
Just for testing I need to turn off the scan channel function/policy on the radio chip.
Is that possible using telnet comands?

Thaks
Regards

______________________________________________

Posted: Fri Feb 15, 2013 7:55 pm Post subject:
upgrade 1st and use turbo

_______________________________________________

Posted: Fri Feb 15, 2013 6:40 pm Post subject: Temporary force 40 Mhz operation on WR1043ND
Is there any way of forcing the radio to do not scan channels and start in 40 Mhz mode (HT 40)?

I need to conduct some test at home and I do need to know for sure that the radio in my router is in HT 40 mode.

My router is a TP-Link TL-wr1043ND running DD-WRT v24-sp2 std revision 20119.

Thanks in advance.
Regards

[luxury54]

if you upgrade to any vers. of openwrt or gargoyle you can force the noscan feature with these telnet commands, in dd-wrt they have no effect

uci set wireless.radio0.htmode=HT40+
# or: HT40- if using channel 11 with 40Mhz
uci set wireless.radio0.noscan=1
uci commit wireless; wifi

[anishannayya]

Simply change the toggle from dynamic to turbo. Then it'll stick to 40 MHz.

[mazey]

i have 40 mhz (Turbo) selected and Channel 1 (upper) works fine on my 1043ND r20675