The problem
I bought the client especially to use it as wireless bridge. Flashed without any problem. I access the router withot any problem before setting up wireless bridge.
After I setup the client as I wireless bridge, I cannot connect to it via cable. Every one of the PCs I tried is stuck in endless "trying to connect" mode. The client router is not accessible neither via the old IP(192.168.1.1), nor via the new one(192.168.1.6).
Both PCs I tried are with Ubuntu 12.04.
Any ideas what might be going wrong, am I missing something?
According to the tutorial in SR1 wireless bridge is not working. What about SR2?
The files I used for my new firmware:
http://dd-wrt.com/site/support/other-downloads?path=others%2Feko%2FBrainSlayer-V24-preSP2%2F
If I get it right, I have not picked up the right hardware for client bridge and my options are WDS#Atheros and Client setup.
Since WDS requres both devices to have the same chipset, I should go for Client or buy a new primary router, right?
Thank you for your help
I tried setting uo the client router to Client mode(NO bridge)
The configuration goes as planned, but the router does not connect to the primary router. Or, for a reason, the client computer(cable connected to the client router) does not have internet access.
[/i]
