As far as having a backup of the settings, is there such thing? or am i better off setting up from scratch every time I flash?
Finally, does Kong still produces his builds, or his are the BS builds?
I haven't seen a Kong built for the D1800H for a long time. it's all BS now. but the good news is that they are both working on from the main SVN. so they are pretty much the same
The setting is good if you need to go back, I suppose.
Here is my take of this backup deal. If I flash, and it breaks.. I can always load the backup bin. If that doesn't work, load the previous firmware and the backup bin.. so at least you have something to work with.
Most of the time, unless I read from another thread it needs to be cleaned out before flashing... I just do a dirty flash. For a good percentage (at least for me) it doesn't break anything.
As in the case of these recent firmware.... it was suggested by Kong to clean out and start fresh, hence exactly what I did.
Posted: Mon Mar 30, 2015 9:23 Post subject: swconfig
I would like to control VIDs used by the switch. My IPS has to VLANs with high VIDs value, out of range 1-16. I found on forum it can be obtained using swconfig command. However, In the latest build 26587 the swconfig is missing. Have it been removed from last firmware releases ?