Port forwarding to specific switch egress port

Post new topic   Reply to topic    DD-WRT Forum Index -> Advanced Networking
Author Message
fractal5
DD-WRT Novice


Joined: 11 Jan 2014
Posts: 23

PostPosted: Mon Dec 21, 2015 0:20    Post subject: Port forwarding to specific switch egress port Reply with quote
I'm not sure if this is considered "advanced" networking, but it is at least a little more complicated than the plain and simple port forwarding.

I want all incoming Internet traffic on port 1000 (TCP) forwarded to 10.0.0.10:1000 (TCP). However, I want to limit this to a specific egress port on the built-in switch in the wireless router.

This is for security reasons. I don't want a scenario where for whatever reason the IP for the computers on the network have changed, and the traffic gets sent to the wrong computer.

Can this be done with dd-wrt? Does it depend on the device dd-wrt is installed on?

It seems this should be quite similar to the iptables command -o, --out-interface

But I don't have an interface per port.

I only have: ath0 ath1 br0 eth0 vlan1 vlan2, this is for a TPLINK TL-WDR3600.
Sponsor
Display posts from previous:    Page 1 of 1
Post new topic   Reply to topic    DD-WRT Forum Index -> Advanced Networking All times are GMT

Navigation

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You cannot attach files in this forum
You cannot download files in this forum